Draper Dual Roller FlexShade NEXD Petunjuk Pemasangan & Pengoperasian - Halaman 3
Jelajahi secara online atau unduh pdf Petunjuk Pemasangan & Pengoperasian untuk Perabotan Dalam Ruangan Draper Dual Roller FlexShade NEXD. Draper Dual Roller FlexShade NEXD 10 halaman. Heavy-duty, clutch-operated window shade
Halaman Cetak
Dual Roller FlexShade
Section 1 - Mounting Endcaps
Please Note: If installing Pocket Headbox or Surface Headbox, please install headbox FIRST
Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
1. Mark surface for placement of endcaps.
2. Drill small starter hole
(if necessary)
surface.
3. Snap endcap covers onto endcaps
Please Note: If endcap covers have been
provided with the shade order, they are included
in the width of the shade measurement and
must be used.
CAUTION:
If installing without a headbox, proceed to
Figure 2, below, NOW.
If installing with a Dual Roller Ceiling/Wall
Headbox, proceed to Section 2 NOW.
If installing with a Dual Roller Pocket
Headbox, proceed to Section 3 NOW.
4. Mount endcaps using appropriate fasteners for
surface
.
(Fig. 2)
CEILING MOUNTING
Figure 2-A
Mount endcaps
to ceiling.
JAMB MOUNTING
Figure 2-C
PLEASE NOTE:
If endcap covers are included in order,
drill through endcap cover and secure with endcap.
Endcap requires a minimum of two fasteners.
It is not necessary to utilize all four corners.
NEXD
®
in mounting
.
(Fig. 1)
Mount endcaps
to ceiling.
Mount
endcaps
to jamb.
.
(Section ????)
Snap endcap
covers
into place.
Figure 1
WALL MOUNTING
Figure 2-B
Mount endcaps
B
A
Please Note: If installing shade or shades in an area
where misuse is likely, this fastening method should
be used.
page 3 of 10
E N D
C A P
C O V
E R
to wall.
please note
Endcaps must be fastened securely
to mounting surface and cannot move
from side to side.
If changes, differences, or
measurement errors occur on-site,
adjust product by utilizing slotted
holes in the endcap [A] to adjust for
zero gap between the fascia and
endcap covers.
Once these adjustments are made,
utilize round holes [B] to drive
additional screws for securing
position.