Draper FlexLouver 50A Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Perabotan Dalam Ruangan Draper FlexLouver 50A. Draper FlexLouver 50A 4 halaman. Rack arm systems

Halaman Cetak

FlexLouver™ Rack Arm Systems by Draper

System operates on 110-120V, 60 Hz. current. Connections should be made in accordance with attached wiring diagram, and wiring should comply with

national and local electrical codes. DO NOT wire motors in parallel without written permission from Draper.

All operating switches should be "off" before power is connected.

1=White

2=Red

3=Black

4=Green

5=Red

6=Black 1

7=Black 2

8=Red

9=White

10=Green

CAUTION: The limits on your FlexLouver Rack Arm System should be

shipped pre-set. If, however, the limits do require adjustment, be sure all

switches are in "off" position before adjusting limit switches. Always be

prepared to shut off manually when new adjustment is being tested. Do not

allow the motor to continue running once the Louvers are fully open or

closed. This might lead to damage to your system.

Wiring Diagram—Belimo Motor

100 to 240 VAC

N L1

H L2

a open

a closed

The indication of direction

is valid for switch position 1.

On/Off Control

Electrical Connections

Wiring Diagram—Standard Motor

5 6 7

3 x 2,5 mm

8 9 10

Limit Switch Adjustments—Standard Motor

(1)

Common

(2)

(3)

1 0

LMX120-3

www.draperinc.com

3 x 0,75 mm

4 x 0,75 mm

1 Determine which direction of Louver movement corresponds with arrows on

motor.

2 Operate to "open" stop position. Adjust limit by turning the proper socket to add

or subtract travel.

3 Operate to "closed" position. Adjust limit by turning the proper socket to fine

tune the "closed" position.

Limit Switch Adjustments—Belimo Motor

Loosen screw, slide block until

the required amount of rota-

tion is set and then tighten to

lock block into position.

(765) 987-7999

Page 3 of 4

When connecting the motor to the system:

1 Rotate the drive shaft until the louvers are

in the fully open position.

2 Press the indicated button on the motor

and rotate the drive until it is against the

fully open block. When in the correct posi-

tion, release the button.

3 Clamp the drive shaft in place.