Draper 65084 Panduan Pengguna - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sander Draper 65084. Draper 65084 16 halaman. Dual action air composite sander
Juga untuk Draper 65084: Manual Petunjuk Asli (20 halaman)
Halaman Cetak
5.
HEALTH AND SAFETY INFORMATION
before making any adjustments, carrying out maintenance operations or just finishing using the
tool.
Remove and check setting tools. Some machinery requires the use of additional tools or keys to
set, load or adjust the power tool. Before starting the power tool always check to make certain they
have been removed and are safely away from the machine.
Prevent unintentional starting. Before plugging any machine in to the power supply, make sure
the switch is in the OFF position. If the machine is portable, do not hold the machine near the
switch and take care when putting the machine down, that nothing can operate the switch.
Concentrate and stay alert. Distractions are likely to cause an accident. Never operate a power
tool if you are under the influence of drugs (prescription or otherwise), including alcohol or if you
are feeling tired. Being disorientated will result in an accident.
Have this tool repaired by a qualified person. This tool is designed to conform to the relevant
international and local standards and as such should be maintained and repaired by someone
qualified, using only original parts supplied by the manufacturer. This will ensure the tool remains
safe to use.
5.2
GENERAL SAFETY INSTRUCTIONS FOR COMPRESSED AIR
These safety instructions should be strictly followed. Failure to do so may result in accidents,
equipment malfunctioning, serious personal injury and / or loss of life.
Compressed air is a source of considerable energy. When handling products dealing with
compressed air, the following precautions must be taken to prevent accidents.
− Ensure that compressed air is not blocked or in contact with any part of your body.
− Before connecting any pneumatic equipment to the compressed air supply, all mounted fittings,
piping assemblies and electrical connections should be checked for security. All plastic plugs in
the equipment used for protection during shipping should be removed.
− No piping alterations, removal of fittings, repairing of equipment etc. Should be attempted with
air supplies connected. Air and electrical supplies must be disconnected before beginning any
adjustment, maintenance or dismantling of equipment.
− The maximum allowable operating pressures, temperature, flows etc. must be strictly
observed. Failure to do so might result in catastrophic failure of equipment, and result in
serious personal injury and / or death. Refer to individual catalogues for this information, and
any other operating or application limitations.
Warning:
− Compatibility of pneumatic equipment
Ensuring the compatibility of the procured FRL equipment is the responsibility of the
person who designs the Pneumatic system and/ or System specifications. This should be
based on specifications or after analysis and / or tests to meet specific requirements.
− Repair and maintenance
Assembly, handling, or repair of pneumatic systems should be performed by only trained and
experienced operators.
− Safety first
Do not service machinery/equipment or attempt to remove any component until safety Is
confirmed.
•
Inspection and maintenance of machinery / equipment should only be performed after
confirmation that both compressed air and electrical supply have been positively
disconnected and all residual compressed air in the system has been completely
exhausted to the atmosphere.
− Contact the manufacturer if equipment is to be used in any of the following conditions:
•
Equipment is to be used in conditions beyond the given specifications, or if equipment is to
be used outdoors.
– 7 –