Bosch WLK20261BY Buku Petunjuk - Halaman 26
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mesin cuci Bosch WLK20261BY. Bosch WLK20261BY 38 halaman.
Halaman Cetak
After-sales service
en
Faults
Residual water in the care
product dispenser.
Odours in the washing
machine.
N symbol flashes. Foam
may escape from the
detergent drawer.
Intense noise, vibrations
and "wandering" during
spinning.
Display panel/indicator
lights do not function
while the appliance is run-
ning.
Detergent residue on the
laundry.
The colon on the
Ready in display : is
flashing.
The single dot (.) flashes. Undervoltage during the washing programme causes an extending of the wash
NO appears in the display
panel in reload mode.
YES appears in the dis-
play panel in reload
mode.
If you cannot correct a fault yourself (after switching on/off) or a repair is required:
Turn the programme selector to Off. Appliance is switched off.
■
Unplug the mains plug from the socket.
■
Turn off the water tap and call the after-sales service. ~ Page 26
■
4
After-sales service
e s
r - s a l
A f t e
If you cannot correct the fault yourself,
26
Cause/Remedy
Not a fault – the effect of the care product is not affected.
■
Clean the insert if necessary.
■
Run the i ü Cottons 90 °C programme without laundry. Use standard
detergent for this.
Too much detergent used?
Mix one tablespoonful of fabric softener with 1/2 litre water and pour into com-
partment II (Not for outdoor fabrics, sportswear fabrics or those made with
down.)
Reduce detergent dosage for the next wash cycle.
Appliance aligned? Level the appliance. ~ Page 33
■
Appliance feet fixed? Secure appliance feet. ~ Page 33
■
Transportation protection devices removed? Remove transportation bolts.
■
~ Page 30
Power failure?
■
Fuse tripped? Switch on/replace the circuit breakers.
■
If the fault occurs repeatedly, call the after-sales service. ~ Page 26
■
Occasionally, phosphate-free detergents contain water-insoluble residue.
■
Select O Rinse or brush the laundry after washing.
■
Mains voltage too low ~ Page 21
programme. ~ Page 21
Water level too high. Not possible to add laundry. Close the washing machine
door immediately, if necessary.
To continue the programme, select the Start/Reload button.
The washing machine door is unlocked. It is possible to add laundry.
(see section, Faults and what to do
about them) ~ Page 24, please
contact our after-sales service. ~
c e
s e r v i
Cover page