Drawmer 1969 Panduan Operator - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Operator untuk Peralatan Perekaman Drawmer 1969. Drawmer 1969 13 halaman. Dual vacuum tube compressor
Juga untuk Drawmer 1969: Panduan Operator (13 halaman)

Halaman Cetak

Bass EQ:

Treble EQ:

Gain:

Low/High:

Flat/EQ:

Norm/Bright:

QUICK SET UP

Select Stereo Link mode for use with a stereo signal, otherwise ensure

this switch is Off.

Choose correct signal source for each channel using selector.

Initially, set the Attack selector to 3 (a Medium position) and set Release

to 6 (Programme Dependent).

Set the Mode switch to Normal and the Meter switch to GR.

With programme material playing, adjust the Threshold control until the

desired amount of gain reduction registers on the meters.

Use the Output Gain control to restore any level lost due to compression.

If necessary, change the Attack and Release settings to suit the material.

Passive equaliser control, which can be set to provide up to

15dB of bass boost at 40Hz.

Passive equaliser control, which can be set to provide up to

18dB of treble boost at 16kHz.

Provides up to 30dB of gain at the Low Gain switch setting

or 40dB at the High Gain setting.

Sensitivity selector switch. Adds 10dB of gain in the High

position.

Switches the equaliser controls out of circuit when a flat

response is required, or for 'A/B' comparison of EQ

effectiveness.

Switches in 10dB of boost at 2kHz in the Bright position, (

when 'EQ' has been selected on the Flat/EQ switch.)

1969 OPERATORS' MANUAL