Drawmer 1976 Panduan Operator - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Operator untuk Perangkat Keras Komputer Drawmer 1976. Drawmer 1976 13 halaman. Stereo 3 band saturation and width processor

Halaman Cetak

A typical setup for connecting the 1976 would be by the use of a Y-lead between the two input and output

xlr's on the rear of the 1976 and insert point for the respective channel of the desk or interface for the digital

workstation - this would be repeated for both channels. The wiring of the Y-lead can be seen below.

The inputs and outputs are electronically balanced on conventionally wired XLRs (pin 1 screen, pin 2 hot,

pin 3 cold and XLR shell is connected to chassis). The operating level is nominally +4dBu. Balanced use is

recommended.

For connecting the 1976 to a mixing desk use the insert points as shown in the following diagram:

Alternatively, if you are using a digital workstation and have an audio interface that does not have insert

points, connect it to the analogue send (out) and return (in) of the relevant channels via four XLR to XLR/

jack cables. See your interface and software user manuals for the best procedure.

• Ground Loops:

If ground loop problems are encountered, never disconnect the mains earth, but instead, try disconnecting

the signal screen on one end of each of the cables connecting the outputs of the 1976 to the patchbay. If

such measures are necessary, balanced operation is recommended.

• Interference:

If the 1976 is to be used where it maybe exposed to high levels of disturbance such as found

close to a TV or radio transmitter, we advise that it is operated in a balanced configuration. The

screens of the signal cables should be connected to the chassis connection on the XLR connector

as opposed to connecting to pin1.

The 1976 conforms to the EMC standards.

AUDIO CONNECTIONS

DRAWMER 1976 O

PERATOR'S

ANUA