Bosch 800 Series Panduan Instalasi - Halaman 12

Close the oven door until it catches on the hinge stop

levers, locking the hinges at the correct angle for door

removal. The door can be removed when it is pulled

up from the open position by about 8 inches

(203 mm). This takes the tension off the spring-loaded

hinges so that the door can be easily lifted out.

CAUTION

RISK OF PINCHING

Closing the door by 8" (203 mm) takes the

pressure off the spring. If this is not done, the

door can still be removed but the latch will now

slam shut and will pinch or cut your hand.

The door is heavy. Use both hands to firmly grip it by

the sides. Do not grip the door by the handle. Keeping

the angle of the door the same, lift the door straight up

approximately 3/4" (19 mm) to unhook the hinges

from the slots, and then pull it out towards you until the

hinges are clear of the oven housing.

Place the door in a convenient and stable location for

cleaning.

Refit the door in the reverse order in which it was

removed.

Fitting the Rear Vent Trim

The rear vent trim is nested in the styrofoam

packaging. Remove the packaging and the protective

film from the rear vent trim.

Place the rear vent trim into the holes intended for this

purpose using the dowel pins.

Insert and tighten the enclosed screws from below.

Remove all parts that are not permanently fixed,

especially the pan supports and burners.

Remove the accessories from the oven.

CAUTION

Protect the floor.

Tilt the appliance and put it to the floor on the

backside.

CAUTION

Do not use the door handle or projecting control

panel for carrying.