Bosch Benchmark Series Panduan Servis - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Servis untuk Oven Bosch Benchmark Series. Bosch Benchmark Series 36 halaman. Built-in wall ovens
Juga untuk Bosch Benchmark Series: Panduan Instalasi (32 halaman), Panduan Referensi Cepat (4 halaman), Panduan Servis (45 halaman), Panduan Petunjuk Instalasi (40 halaman), Panduan Memulai Cepat dan Keselamatan (13 halaman)

Halaman Cetak
Bosch Benchmark Series Panduan Servis
58300000187895 ARA EN A
2
1
Figure 14 Latch in locked position
There is a Door Lock Relay Test available in Service mode. See the
Service Mode section for details.

7.2.1 Replacing the Latch/Motor Assembly

1. Remove power to the range.
2. Remove the inner screws securing the latch to the latch plate,
then remove the outer screws securing the latch plate to the
range.
Figure 15 Front latch plate; remove/replace screws in order shown
3. Hold the latch hook and slide the latch assembly a little to the
left to disengage it from the small support bracket that sits
directly behind it, then pull the latch forward.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2015
Figure 16 Door latch/motor assembly and rear support bracket
4. Disconnect the wires.
5. Install the new latch/motor assembly, reconnecting the wires
and engaging the latch correctly with the latch support bracket.
6. Position the latch plate with the curved corners at the bottom,
and reinsert screws.
7. Restore power and test operation.
7.3
The resettable HTC is a normally closed 12VDC thermal switch that is
used to detect over-temperature conditions within the oven. It has a
connector that will interrupt the double line break (DLB) relay coil
voltage supply if the temperature reaches 185°C/365°F. When the
HTC switch opens, it breaks the line to the double line break (DLB)
relays, cutting off power to the elements.
With the latch plate removed, the HTC and the bracket it's mounted
on are visible to the left of the door latch/motor assembly. The photo
below shows the HTC and bracket.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Induction Slide-in Ranges

Oven High Temperature Cutout (HTC)

Page 17 of 36
800 944-2904