Bosch Benchmark Series Panduan Servis - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Servis untuk Oven Bosch Benchmark Series. Bosch Benchmark Series 36 halaman. Built-in wall ovens
Juga untuk Bosch Benchmark Series: Panduan Instalasi (32 halaman), Panduan Referensi Cepat (4 halaman), Panduan Servis (45 halaman), Panduan Petunjuk Instalasi (40 halaman), Panduan Memulai Cepat dan Keselamatan (13 halaman)

Halaman Cetak
Bosch Benchmark Series Panduan Servis
58300000187895 ARA EN A
Figure 24 Sheet metal tabs for securing convection fan motor to rear of oven
8. Install the new motor, being sure to bend the three sheet metal
tabs back in.
9. Reinstall the fan blade and baffle.
10. Restore power and test operation.
11. Slide the range back into the cutout, being sure to properly
engage the anti-tip bracket.
7.7

Broil Element

The 240V 3800W broil (upper) element is attached to a reflector,
which helps to direct the heat evenly toward the food.
Refer to the Element Strip Diagram section to test the broil element at
the control module. A Broil Element Relay Test is also available in
Service mode. See the Service Mode section for details.
If the wires are disconnected from the element terminals, an
ohmmeter can be used to check for resistance of ~15 ohms.

7.7.1 Replacing the Broil Element

1. Remove power to the range.
2. Detach the element from the reflector.
3. Remove the two screws from the terminal area on the rear
cavity wall.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2015
4. Pull the element forward carefully (there is not much excess
wire) so that the terminal connections move inside the cavity.
5. Disconnect the wires from the terminals, being careful not to
let the harness wires drop back out of reach.
 If the wires are too short to disconnect from the front,
 If the wires were successfully disconnected, skip to step 8.
5. Carefully slide the range out of the cutout to gain access to the
element terminals from the rear of the unit.
6. Disconnect the wire leads from the terminals.
7. Install the new element.
8. Restore power and test operation.
9. If necessary, slide the range back into the cutout, being sure to
properly engage the anti-tip bracket.
7.8
The 240V 2400W bake element is concealed in the base of the oven.
Access to the rear of the unit is necessary when replacing the
element.
Refer to the Element Strip Diagram section to test the bake element at
the control module. A Bake Element Relay Test is also available in
Service mode. See the Service Mode section for additional
information.
If the wires are disconnected from the element terminals, an
ohmmeter can be used to check for resistance of ~24 ohms.

7.8.1 Replacing the Bake Element

1. Carefully slide the range out of the cutout to gain access to the
bake element from the rear of the unit.
2. Disconnect the wires from the element terminals.
3. Remove the screws securing the bake element access panel.
4. Bend the access panel downward to expose the element.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Induction Slide-in Ranges
continue with step 5.

Bake Element

Page 22 of 36
800 944-2904