Bosch Benchmark Series Panduan Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Oven Bosch Benchmark Series. Bosch Benchmark Series 32 halaman. Built-in wall ovens
Juga untuk Bosch Benchmark Series: Panduan Servis (36 halaman), Panduan Referensi Cepat (4 halaman), Panduan Servis (45 halaman), Panduan Petunjuk Instalasi (40 halaman), Panduan Memulai Cepat dan Keselamatan (13 halaman)

Attaching the mounting plate to the wall

Preparing rear wall

CAUTION

Wear gloves to avoid cutting fingers on sharp

edges.

Note: Make sure the cabinet bottom is level.

Draw a vertical line on the wall at the center of the

cabinet space.

Cabinet with front overhang: Draw a line on the back

wall equal to the depth of the front overhang.

Tape the REAR WALL TEMPLATE onto the wall

matching the centerline and touching the bottom of the

cabinet or the level line.

Draw a horizontal line on the wall at the bottom of the

Rear Wall Template.

Drill holes at locations A and B:

3/16" (5 mm) holes for wood screws (stud)

▯

5/8" (16 mm) holes for toggle bolts (no stud)

▯

Note: If neither A nor B is in a stud, find a stud

somewhere in the area of the mounting plate and drill

a 3/16" (5 mm) hole.

It is important to use at least one wood screw mounted

firmly in a stud to support the weight of the microwave.

Wall venting installation only: Cut out the shaded

area "F" on the REAR WALL TEMPLATE using a saber

or keyhole saw.

CAUTION

If exhaust adaptor is positioned outside consider

recommended dimensions, otherwise grease-

laden air will discharge into house structure.

Remove REAR WALL TEMPLATE.

Attaching the mounting plate

Remove the toggle wings from the bolts.

Insert the bolts into the mounting plate through the

holes designated to go into drywall.

Attach toggle wings from the back of the mounting

plate onto each bolt. Leave enough space for toggle

wings to go through the wall and to open.

Place the mounting plate against the wall and push the

bolts through the drywall.

Finger tighten the bolts to make sure toggle wings

have opened against drywall.

Verify that the plate is properly centered and level.

Securely tighten all screws, including the wood screw.