Bosch CMG633B.1A Panduan Pengguna dan Petunjuk Instalasi - Halaman 25
Jelajahi secara online atau unduh pdf Panduan Pengguna dan Petunjuk Instalasi untuk Oven Bosch CMG633B.1A. Bosch CMG633B.1A 41 halaman.
Halaman Cetak
Fault
The time is not dis-
played when the ap-
pliance is switched
off.
The control ring has
fallen out of the
mount in the control
panel.
The control ring is dif-
ficult to turn.
During simple mi-
crowave operation,
the cooking compart-
ment becomes hot.
The interior lighting
does not work.
Maximum operating
time reached.
A message with "D"
or "E" appears in the
display, e.g. D0111
or E0111.
The cooking result is
not satisfactory.
Cause and troubleshooting
Basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 19
The control ring has been detached.
Insert the control ring into the mount in the control panel.
1.
Push the control ring into the mount so that it clicks into place and can be turned.
2.
There is dirt below the control ring.
The control ring can be removed.
Note: To ensure that the mount remains stable, do not remove the control ring too often.
To loosen the control ring, press on the outer edge of the control ring.
1.
a The control ring tilts and is easier to grip.
Remove the control ring from the mount.
2.
Clean the control ring and its mount on the appliance carefully using soapy water and a
3.
dish cloth. Dry with a soft cloth.
Do not use any harsh or abrasive cleaning agents.
Do not soak the control ring.
Do not clean the control ring in the dishwasher.
The drying function is switched on.
To prevent condensation during simple microwave operation, the appliance automatically
switches on the top heating for levels 600 W and max. The cooking result is not affected by
this.
You can change the basic setting for the drying function during microwave operation.
▶
→ "Basic settings", Page 19
Take note of the information for the microwave.
‒
→ "Microwave", Page 16
The LED light is defective.
Note: Do not remove the glass cover.
Call the after-sales service.
▶
→ "Customer Service", Page 26
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
To continue the operation, press any touch field and turn the control ring.
1.
If you do not need to use the appliance, use
2.
Tip: To prevent the appliance from switching off when you do not want it to, set a cooking
time.
→ "Setting the cooking time", Page 15
The electronics have detected a fault.
Switch the appliance off and on again.
1.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the exact error
2.
message when calling.
→ "Customer Service", Page 26
Settings were unsuitable.
Setting values, e.g. temperature or cooking time, depend on the recipe, quantity and food.
Next time, set lower or higher values.
▶
Tip: A lot of information about the food preparation and corresponding setting values
can be found on our website www.bosch-home.com.
Troubleshooting en
to switch it off.
25