Bosch FAP-OC 500Series Panduan Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Oven Bosch FAP-OC 500Series. Bosch FAP-OC 500Series 32 halaman. Built-in wall ovens
Juga untuk Bosch FAP-OC 500Series: Panduan Petunjuk Instalasi (21 halaman), Petunjuk Penggunaan Manual (40 halaman), Panduan Instalasi (6 halaman), Informasi Produk (40 halaman), Panduan Instalasi (28 halaman), Panduan Pengguna (48 halaman), Panduan Pengguna (48 halaman), Panduan Instalasi (28 halaman), Panduan Penggunaan dan Perawatan (44 halaman), Panduan Instalasi (32 halaman), Panduan Penggunaan dan Perawatan / Petunjuk Pemasangan (40 halaman), Panduan Referensi Cepat (4 halaman), Panduan Penggunaan dan Perawatan (27 halaman), Panduan Instalasi (24 halaman), Panduan Penggunaan dan Perawatan (24 halaman), Panduan Instalasi (28 halaman), Panduan Servis (41 halaman), Panduan Penggunaan dan Perawatan (21 halaman), Panduan Instalasi (32 halaman), Panduan Servis (36 halaman), Panduan Instalasi (32 halaman), Panduan Memulai Cepat dan Keselamatan (13 halaman)

Install Appliance

Note: To avoid possible damage to the work surface or

to the bottom of the appliance, cover the work surface.

Remove any remaining contents from the microwave

oven cavity.

Remove the screws from the mounting plate.

The mounting plate will be used as the rear wall

template and for mounting.

Reinstall the screws into the holes where they were

removed.

Note: To avoid damage to the microwave oven, do not

grip or use the door or door handle while the microwave

oven is being handled.

Note: The microwave must be connected to at least one

wall stud. If no wall studs exist within the cabinet

opening, do not install the microwave oven.

Locate the edges of the wall studs within the cabinet

opening by using:

- a stud finder or

- a hammer (tapping lightly across the mounting

surface to find a solid sound).

Place a mark halfway between the edges and draw a

line down the center of the studs (See possible wall

studs configuration).

These depictions show examples of preferred installation

configurations with the mounting plate.

Note: Care must be taken when drilling holes. Electrical

wires may be concealed behind the wall covering and

contact with them could result in electrical shock.

No wall studs at corner holes

If wall stud is within 6¼" (159 mm) of the vertical

centerline, only Room Venting (recirculation) or Roof

Venting installations can be done.

Wall stud at one corner hole

Wall studs at both corner holes