Electrolux ZKH7427OS Buku Instruksi - Halaman 14

Jelajahi secara online atau unduh pdf Buku Instruksi untuk Oven Electrolux ZKH7427OS. Electrolux ZKH7427OS 19 halaman. Built-in ovens

Halaman Cetak

Instructions for the installer

The instructions given below are

designed specifically for a qualified

installer and should aid him or her to

perform all installation, adjustment,

and maintenance operations with

absolute precision and in compliance

with all current legislation and

regulations. We strongly recommend

that all operations for the installation

of your cooker be carryed out by

Qualified Personnel in accordance

with existing rules and regulations.

Electrical connection

Prior to making the electrical connection,

make sure that:

— the protection fuse and the domestic wiring

system are suitable to carry the total

electric load of the oven (see rating plate);

— your domestic wiring system has an

efficient earth connection in compliance

with rules and laws in force;

— the wall socket or the omnipole switch used

for the electrical connection can easily be

reached after the oven is built in.

This appliance is delivered without an

electric supply cable, therefore, you will

have to fit to it a supply cable with standard

plug, suitable for the total electric load

shown on the rating plate. The plug is to

be inserted into a suitable wall socket. If

you require a direct connection to the

electric network (mains), it will be

necessary to fit between the appliance and

the mains an omnipole switch, with a

minimum gap between contacts of 3 mm,

suitable for the required load and in

compliance with rules in force. The green

and yellow ground wire must not be

interrupted by the switch, and should be 2-

3 cm longer than the phase and neutral

wires. The supply cable must in all cases

be laid out in such a way as to ensure that

it does not reach at any given point a

temperature 50°C higher than the ambient

temperature.

Suitable power supply cables are the

following types, considering the respective

necessary section of cable: H07 RN-F, H05

RN-F, H05 RR-F, H05 VV-F, H05 V2V2-F

(T90), H05 BB-F.

Connecting the terminal board

The appliance incorporates an easily

accessible 6-pole terminal board whose

jumpers (bridges) are already pre-set for

operation on 400V tri-phase with neutral

wire (Fig. 13). In case a different mains

voltage is present, the jumpers on the

terminal board must be rearranged as

shown in the diagram (Fig. 14). The ground

cable must be connected to terminal

After connecting the supply cable to the

terminal board, secure it with a junction

clamp.

Fig. 13

FO 0330

230V 3~

230V 1~

400V 2N~

400V 3N~

Fig. 14

FO 0584

1 2 3 4 5

L3 PE

1 2 3 4 5

L1 L2

1 2 3 4 5

L1 L2 L3 N