Bosch HB.21B Buku Petunjuk - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Oven Bosch HB.21B. Bosch HB.21B 20 halaman.

Halaman Cetak

Unhooking and hanging the oven door

The front panel can be unhooked to help remove the oven door
and clean the glass panels.
The oven door hinges are fitted with a locking lever. The door
cannot be unhooked if the locking lever is closed (figure A).
Once the locking lever has been opened to unhook the door
(figure B), the hinges will be locked in position. This prevents
the door from suddenly closing.
$
:
Risk of injuries.!
The hinges may close suddenly if they are not locked in
position by the lever. Note that the locking levers are always
closed, apart from when unhooking the door, when the levers
must be open.
Unhooking the door
Fully open the oven door.
1.
Remove both locking levers located on the right and left hand
2.
sides (figure A).
Fully close the oven door as far as possible (figure B). Grip
3.
the left and right hand sides of the door with both hands.
Close the door slightly more and remove it.
$
Hanging the door
Rehang the door by following the same steps but in reverse
order.
When refitting the door, check that both hinges are
1.
positioned exactly inside their respective openings (picture
A).
The bottom groove of the hinges must fit snugly on both
2.
sides.
$
The door may be left crooked if the hinges are not mounted
properly.
%
%
%
Reclose the attachment levers (picture C). Close the oven
3.
door.
&
:
Risk of injuries.!
Do not touch the hinges; the door might accidentally fall or a
hinge might suddenly close. Notify the Technical Assistance
Service.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the
oven door.
Dismantling
Unhook the oven door and place it on a cloth with its handle
1.
pointing downwards.
Remove the upper cover from the oven door. To do this,
2.
press with your fingers on the tabs on the left and right
(Figure A).
Lift and remove the top glass panel (Figure B).
3.
$
In doors with three glass panels, the following step will also be
necessary:
Lift and remove the glass panel (Figure C).
4.
&
Clean the glass panels using a glass cleaning product and a
soft cloth.
Do not use abrasive or corrosive cleaning products, glass
scrapers or hard metal scourers as these could damage the
glass.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, or sharp or abrasive
cleaning aids or detergents.
%
9