Electrolux 400 SERIES Panduan Petunjuk Instalasi - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin cuci Electrolux 400 SERIES. Electrolux 400 SERIES 50 halaman. Front load dryer
Juga untuk Electrolux 400 SERIES: Panduan Penggunaan & Perawatan (16 halaman), Panduan Penggunaan & Perawatan (39 halaman), Panduan Penggunaan & Perawatan (28 halaman), Panduan Penggunaan & Perawatan (46 halaman)
Halaman Cetak
Installation Instructions
10
Leveling your washer
Excessive noise and vibration can be pre-
vented by properly leveling the washer.
1. For free
standing
installation
and with the
washer within
4 feet (1 m) of
its final loca-
tion, place a level on top of the washer.
2. Use the universal wrench to adjust the
leveling legs so
the washer is
level front-to-
rear and side-
to-side, and
stable corner-
to-corner.
3. Press down
on alternate
corners and
sides and feel for the slightest move-
ment. Adjust the appropriate leg(s) so
the washer sits
solidly on the floor
on ALL four legs.
Keep the leveling
leg extension at a
minimum for best
performance of
the washer.
NOTE
For pedestal installations, see additional
installation instructions included with the
pedestal.
Connecting inlet water
1. Run some water
from the hot and cold
faucets to flush the
water lines and remove
particles that might
clog the water valve
screens and to deter-
mine which faucet is
hot and which is cold
supply.
2. Check to ensure
that the inlet
hoses have the
rubber washer
firmly in place.
raise
lower
Rubber Washers
Must Be Present
NOTE
Hoses are not included with washer
purchase. See "Accessories" section for
various inlet hose kits to fit your specific
installation.
3. Connect the HOT
inlet hose to the
HOT inlet con-
nection on the
washer and the
COLD inlet hose
to the COLD
inlet connection
on the washer.
IMPORTANT
The cold water inlet will have a blue cap
cover on the inlet connection and the
hot water inlet will have a red cap cover
on the inlet connection. Additionally,
depending on the model, the hot and
cold inlet connections will be marked
with either an adhesive label or markings
directly on the unit to indicate which side
is cold and which side is hot.
Tighten by hand
until snug. Then
tighten each sup-
ply connection
another 2/3 turn
with pliers.
Do not cross thread or over-
tighten these connections.
4. Connect the HOT
inlet hose to the
HOT water supply
and the COLD inlet
hose to the COLD
water supply.
USE ONLY
NEW HOSES
Cold
Hot
Cold inlet shown
on left side (select
models only)