Electrolux 506062 Manual - Halaman 10

Jelajahi secara online atau unduh pdf Manual untuk Mesin cuci Electrolux 506062. Electrolux 506062 28 halaman.

Halaman Cetak

Introduction

Transport (i.e. transfer of the appliance from one place

to another) and handling (i.e. transfer inside work-

places) must occur with the use of special equipment

of adequate capacity.

The appliance must only be transported, handled and

stored by qualified personnel, who must have:

specific technical training and experience;

knowledge of the safety regulations and applicable

laws in the relevant sectors;

knowledge of the general safety provisions;

the ability to recognize and avoid any possible haz-

ard.

E1.1

Transport: Instructions for the carrier

WARNING!

Do not stand under suspended

loads

during

unloading phases. Unauthor-

ized personnel must not access

the work zone.

IMPORTANT!

appliance's

The

is not sufficient to keep it

steady.

The transported load can shift:

- when braking;

- when accelerating;

- in corners;

- on particularly rough roads.

Handling

Arrange a suitable area with flat floor for appliance

unloading and storage operations.

E2.1

Procedures for handling operations

For correct and safe lifting operations:

•

use the type of equipment most suitable for charac-

teristics and capacity (e.g. lift trucks or electric pal-

let truck);

•

cover sharp edges;

•

check the forks and lifting procedures according to

the instructions given on the packing.

Before lifting:

•

send all operators to a safe position and prevent

persons from accessing the handling zone;

•

make sure the load is stable;

•

make sure no material can fall during lifting, and

manoeuvre vertically in order to avoid impacts;

TRANSPORT, HANDLING AND STORAGE

the

loading/

weight alone

•

handle the appliance, keeping it at minimum height

from the ground.

CAUTION!

For appliance lifting, do not use mova-

ble or weak parts such as casings,

electrical raceways, pneumatic parts,

etc., as anchoring points.

E2.2

Translation

The operator must:

•

have a general view of the path to be followed;

•

stop the manoeuvre in case of hazardous situa-

tions.

E2.3

Placing the load

Before placing the load make sure the path is free and

that the floor is flat and can take the load.

Storage

The appliance and/or its parts must be stored and pro-

tected against damp, in a non-aggressive place free of

vibrations and with room temperature of between -

10°C / 14°F and 50°C / 122°F.

The place where the appliance is stored must have a

flat support surface in order to avoid any twisting of the

appliance or damage to the support feet.

IMPORTANT!

Appliance

lation and disassembly must be

carried out by a specialized

technician.

IMPORTANT!

Do not make modifications to

the parts supplied with the

appliance

faulty parts must be replaced

with original parts.

positioning, instal-

. Any missing or