Electrolux 506063 Manual - Halaman 10
Jelajahi secara online atau unduh pdf Manual untuk Mesin cuci Electrolux 506063. Electrolux 506063 28 halaman.
![Electrolux 506063 Manual](/uploads/products/server2/1380309/1380309.png)
E
E1
Introduction
Transport (i.e. transfer of the appliance from one place
to another) and handling (i.e. transfer inside work-
places) must occur with the use of special equipment
of adequate capacity.
The appliance must only be transported, handled and
stored by qualified personnel, who must have:
-
specific technical training and experience;
-
knowledge of the safety regulations and applicable
laws in the relevant sectors;
-
knowledge of the general safety provisions;
-
the ability to recognize and avoid any possible haz-
ard.
E1.1
Transport: Instructions for the carrier
WARNING!
Do not stand under suspended
loads
during
unloading phases. Unauthor-
ized personnel must not access
the work zone.
IMPORTANT!
appliance's
The
is not sufficient to keep it
steady.
The transported load can shift:
- when braking;
- when accelerating;
- in corners;
- on particularly rough roads.
E2
Handling
Arrange a suitable area with flat floor for appliance
unloading and storage operations.
E2.1
Procedures for handling operations
For correct and safe lifting operations:
•
use the type of equipment most suitable for charac-
teristics and capacity (e.g. lift trucks or electric pal-
let truck);
•
cover sharp edges;
•
check the forks and lifting procedures according to
the instructions given on the packing.
Before lifting:
•
send all operators to a safe position and prevent
persons from accessing the handling zone;
•
make sure the load is stable;
•
make sure no material can fall during lifting, and
manoeuvre vertically in order to avoid impacts;
12
TRANSPORT, HANDLING AND STORAGE
the
loading/
weight alone
•
handle the appliance, keeping it at minimum height
from the ground.
CAUTION!
For appliance lifting, do not use mova-
ble or weak parts such as casings,
electrical raceways, pneumatic parts,
etc., as anchoring points.
E2.2
Translation
The operator must:
•
have a general view of the path to be followed;
•
stop the manoeuvre in case of hazardous situa-
tions.
E2.3
Placing the load
Before placing the load make sure the path is free and
that the floor is flat and can take the load.
E3
Storage
The appliance and/or its parts must be stored and pro-
tected against damp, in a non-aggressive place free of
vibrations and with room temperature of between -
10°C / 14°F and 50°C / 122°F.
The place where the appliance is stored must have a
flat support surface in order to avoid any twisting of the
appliance or damage to the support feet.
IMPORTANT!
Appliance
lation and disassembly must be
carried out by a specialized
technician.
IMPORTANT!
Do not make modifications to
the parts supplied with the
appliance
faulty parts must be replaced
with original parts.
positioning, instal-
. Any missing or