AirStage UTY-RHKY Panduan Instalasi - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Kontrol Jarak Jauh AirStage UTY-RHKY. AirStage UTY-RHKY 8 halaman. Uty-rhk series
Juga untuk AirStage UTY-RHKY: Panduan Pengoperasian (2 halaman), Panduan Pengoperasian (20 halaman)
Halaman Cetak
Function number and setting number setting
(3) "Function number" indicator blinks. Then display Number by pressing
the "
" button or "
(4) When the "Setting number" blinks by pressing the "
button set the Setting number by pressing the "
or "
" button.
(5) Fix the setting by pressing the "
(Data is transferred to the indoor unit).
PROHIBITED
•
(-- is displayed,) if not set the
indoor unit.
•
Set again as per procedures
(3)-(5) above.
Completion of address setting mode
(6) Function setting mode is released and returns to normal indicator
if the "
" button, "
"
" button are pressed for more than
5 seconds simultaneously.
* Function setting mode is released automatically if no key is pressed
for 60 seconds even the above buttons are not pressed.
(Switch to Function setting mode as per procedure (1) above.)
(7) After completing the FUNCTION SETTING, be sure to turn off the
power and turn it on again.
En-7
" button.
Function number
"
" button
Setting number
Ex. When Setting number "12"
is selected.
" button.
GOOD
When set properly in the indoor
unit.
" button and
Normal mode indicator
10. TEST RUN
E T H O D S
This unit does not activate the test run. Test run can be activated by the
other remote controllers.
Note:
•
When "
" is indicated on temperature indicator, it means
under test run.
•
When "
" is indicated on temperature indicator, it means
under maintenance.
Indoor unit cannot be operated.
11. FILTER LAMP RESET
Some indoor unit models are equipped with a fi lter lamp in the indoor unit
display to indicate when it is time to clean the air fi lters.
Press the "
" button for 2 seconds or more.
The indoor unit fi lter lamp will go off and the fi lter indicator will disappear.
12. ERROR CODE
If there is a problem with the air conditioner, it will stop running and "
be displayed.
If an error occurs, it appears automatically on the display as shown below.
Error code
Faulty unit No.
(0-15, C0)
If "
" is displayed, immediately contact authorized service personnel.
Do not used the operation below if an error has occurred.
•
When 0-15 is indicated on the Faulty unit No., error has occurred at the
indoor unit. Refer to the indoor unit installation manual.
Faulty unit No.
Error code
" will
Contents
Indoor unit ↔ remote controller
communication error
Incompatible indoor unit is con-
nected