Bosch HBA63B4.0A Buku Petunjuk - Halaman 15
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Oven Bosch HBA63B4.0A. Bosch HBA63B4.0A 28 halaman.
Halaman Cetak
Problem
Possible cause Remedy/information
The oven does
The oven is in
not heat up. The
demonstration
colon in the
mode.
display flashes.
F8 appears in
Automatic
the display.
switch-off has
been activated.
Error messages
If an error message with
"
reset the clock. If the error message appears again, call the
after-sales service.
You can take remedial action yourself if the following error
messages are displayed.
Error message Possible cause Remedy/information
A button was
"‹‚‚
depressed for
too long or is
covered up.
The
"‹‚†
temperature in
the cooking
compartment is
too high.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
After-sales service
Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
E number and FD number
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate containing these numbers
can be found on the right-hand side of the oven door. You can
make a note of the numbers of your appliance and the
telephone number of the after-sales service in the space below
to save time should it be required.
E no.
After-sales service
O
Switch off the circuit
breaker in the fuse box and
switch it on again after
approximately 20 seconds.
Now, within approx.
2 minutes, press and hold
the
D
button for approx.
4 seconds until the colon
lights up constinuously.
Turn the function selector to
the off position.
appears, press the
0
button. Then
Press all buttons
individually. Check whether
any buttons are jammed,
covered up or soiled.
The oven door locks and
heating is suspended. Wait
until the oven has cooled
down. Press the
0
and reset the clock.
FD no.
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
ã=
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Remove the glass cover. To do this, press back the metal
2.
tabs with your thumb (Fig. A).
Unscrew the bulb and replace it with one of the same type
3.
(Fig. B).
$
Refit the glass cover. When doing this, insert it on one side
4.
and press firmly on the other side. The glass cover will click
into place.
Remove the tea towel and switch on the circuit breaker.
5.
button
Glass cover
You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
To book an engineer visit and product advice
0844 8928979
GB
Calls from a BT landline will be charged at up to 3
pence per minute. A call set-up fee of up to 6 pence may
apply.
01450 2655
IE
Trust the expertise of the manufacturer, and rest assured that
the repair will be carried out by trained service technicians
using original spare parts for your domestic appliance.
%
15