Bosch HBC84K553A Buku Petunjuk - Halaman 12
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Oven Bosch HBC84K553A. Bosch HBC84K553A 32 halaman. Oven
Halaman Cetak
Automatic switch-off
If you do not change the settings on your appliance for several
hours, automatic switch-off is activated. The oven stops heating.
The point at which this occurs depends on the temperature or
grill setting that has been set.
Automatic switch-off is activated
A signal sounds. F8 appears in the display. The oven stops
heating.
Care and cleaning
With careful care and cleaning your microwave oven will retain
its looks and remain good order. We will explain here how you
should care for and clean your appliance correctly.
ã=
Risk of short circuit!
Never use high-pressure cleaners or steam cleaners to clean
the oven.
ã=
Risk of burns!
Never clean the appliance immediately after switching off. Let
the appliance cool down.
Notes
Slight differences in colour on the front of the appliance are
■
caused by the use of different materials, such as glass,
plastic and metal.
Shadows on the door panel which look like streaks, are
■
caused by reflections made by the oven light.
Enamel is baked on at very high temperatures. This can
■
cause some slight colour variations. This is normal and does
not affect their function. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.
Unpleasant odours, e.g. after fish has been prepared, can be
■
removed very easily. Add a few drops of lemon juice to a cup
of water. Place a spoon into the container as well, to prevent
delayed boiling. Heat the water for 1 to 2 minutes at
maximum microwave power.
Cleaning agents
To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use
sharp or abrasive cleaning agents,
■
metal or glass scrapers to clean the glass in the appliance
■
door,
metal or glass scrapers to clean the door seal,
■
hard scouring pads and sponges,
■
cleaning agents with high concentrations of alcohol.
■
Wash new sponge cloths thoroughly before use.
12
Turn the function selector to the off position. The oven switches
off.
Overriding automatic switch-off
So that automatic switch-off is not activated when it is not
wanted, you can set a time period. The oven will heat until this
period has expired.
Area
Cleaning agents
Appliance front
Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Do not use glass cleaners or
metal or glass scrapers for cleaning.
Stainless steel
Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Remove flecks of limescale,
grease, starch and albumin (e.g. egg
white) immediately. Corrosion can form
under such residues. Special stainless
steel cleaning agents can be obtained
from the after-sales service or from
specialist shops.
Oven
Hot soapy water or a vinegar solution:
Clean with a dish cloth and dry with a
soft cloth.
If oven is very dirty: use oven cleaner,
but only when oven is cold. It is best to
use a stainless-steel sponge.
Glass cover for the
Hot soapy water:
oven light
Clean with a dish cloth.
Control panel/outer
Glass cleaner:
door panel
Wipe dry immediately using a soft cloth.
Do not use a glass scraper.
Inner door glass
Glass cleaner:
Wipe dry with a soft cloth. Do not use a
glass scraper.
Seal
Hot soapy water:
Clean with a dish cloth, do not scour.
Do not use a metal or glass scraper for
cleaning.
Accessories
Hot soapy water:
Soak and clean with a dish cloth or a
brush.
Self-cleaning surface in the cooking compartment
The back panel of the oven is coated with self-cleaning enamel.
It cleans itself while the oven is in operation. Sometimes, larger
splashes of food may not disappear until the oven has been
operated several times.
Notes
Never treat the self-cleaning surface with oven cleaner. If
■
oven cleaner accidentally gets onto the rear wall, remove it
immediately with a sponge and plenty of water.
Never use abrasive cleaning agents. You will scratch or
■
destroy the highly porous coating.
Never clean the self-cleaning surface with a scouring pad.
■
Light discolouration of the enamel does not affect self-
■
cleaning.