Electrolux ELX913138611 Panduan Pengguna - Halaman 26

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci Electrolux ELX913138611. Electrolux ELX913138611 32 halaman.

Halaman Cetak

www.electrolux.com

The appliance drum

doors are open or

not closed correctly.

The indicator of button Start/Pause flashes in red 11 times and 1 (or 2 or 3) time(s) in

yellow: the mains supply is unstable. Wait until mains supply is stable.

In case of different problem with the washing machine check the

table below for possible solutions.

Problem

The programme does

not start.

The appliance fills

with water and drains

immediately.

The spin phase does

not operate or the

washing cycle lasts

longer than usual.

There is water on the

floor.

You cannot open the

appliance lid.

• Make sure that drum doors are properly closed.

Possible solution

• Make sure that the mains plug is connected to the mains

socket.

• Make sure that the appliance lid and drum door are

closed.

• Make sure that there is no damaged fuse in the fuse box.

• Make sure that the Start/Pause

• If the delay start is set, cancel the setting or wait for the

end of countdown.

• Deactivate the Child Lock function if it is on.

• Check the position of the knob on the selected pro‐

gramme.

• Make sure that the drain hose is in the correct position.

The hose may be positioned too low. Refer to "Installation

instruction".

• Set the spin programme.

• Make sure that the drain filter is not clogged. Clean the fil‐

ter, if necessary. Refer to "Care and cleaning".

• Adjust manually the items in the tub and start the spin

phase again. This problem may be caused by balance

problems.

• Make sure that the couplings of the water hoses are tight

and there is not water leakages.

• Make sure that the water inlet hose and the drain hose

have no damages.

• Make sure you use the correct detergent and the correct

quantity of it.

• Make sure that a washing programme that ends with water

in tub, has not been selected.

• Make sure that the washing programme is finished.

• Set the drain or the spin programme if there is water in the

drum.

• Make sure that the appliance receives electrical power.

• This problem may be caused by a failure of the appliance.

Contact the Authorised Service Centre.

has been touched.