Bosch HBF011BR1 Panduan Pengguna dan Petunjuk Instalasi - Halaman 28

Jelajahi secara online atau unduh pdf Panduan Pengguna dan Petunjuk Instalasi untuk Oven Bosch HBF011BR1. Bosch HBF011BR1 32 halaman.

Bosch HBF011BR1 Panduan Pengguna dan Petunjuk Instalasi
en Installation instructions
¡ Only an appliance which has been correctly in-
stalled in accordance with these installation instruc-
tions can be used safely. The installer shall be liable
for damages incurred as a result of incorrect install-
ation.
¡ Check the appliance for damage after unpacking it.
Do not connect the appliance if it has been dam-
aged in transport.
¡ Proceed in accordance with the installation sheets
for installing accessories.
¡ Before starting up the appliance, remove any pack-
aging material and adhesive film from the cooking
compartment and the door.
¡ Fitted units must be heat-resistant up to 90 °C, and
adjacent unit fronts up to 70 °C.
¡ Do not install the appliance behind a decorative
door or the door of a kitchen unit. Risk of overheat-
ing.
¡ Cut-out work on the units should be carried out be-
fore installing the appliance. Remove any shavings.
Otherwise, the correct operation of electrical com-
ponents may be adversely affected.
¡ To prevent cuts, wear protective gloves. Parts that
are accessible during installation may have sharp
edges.
¡ Dimensions of the figures in mm
16.2 Appliance dimensions
You can find the appliance dimensions here.
¡ The mains socket for the appliance must either be
located in the hatched area A or outside of the area
where the appliance is installed.
¡ Secure freestanding units to the wall using a stand-
ard bracket B.
28
16.3 Installing the appliance below a
worktop
¡ To ventilate the appliance, the intermediate floor
must have a ventilation cut-out.
¡ Secure the worktop to the built-in unit.
¡ Observe the installation instructions for the hob.
16.4 Installation in a tall unit
¡ To ventilate the appliance, the intermediate floor
must have a ventilation cut-out.
¡ If the tall unit has another back panel in addition to
the element back panels, remove this.
¡ Only fit the appliance up to a height which allows
accessories to be easily removed.
16.5 Corner installation
¡ Observe the minimum dimensions in a corner in-
stallation in order to be able to open the cover of
the appliance. The dimension
thickness of the furniture panel and the handle.
depends on the