Electrolux EW 1233I Buklet Instruksi - Halaman 14
Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Mesin cuci Electrolux EW 1233I. Electrolux EW 1233I 29 halaman.
Halaman Cetak12 Programme progress display
By selecting the wash programme, the pilot lights
corresponding to the various phases making up the
programme come on.
After the machine has started, only the running
phase pilot light stays on. When the programme has
finished, the End
pilot light comes on.
The END
pilot light flashes in the event of
operating problems.
At the same time one of the following alarm codes
appear on the display:
E10 = the machine does not fill
E20 = the machine does not empty
E40 = the door has not been closed
To eliminate the problem, see paragraph "Something
not working".
If the pilot light
flashes at the end of the
programme this means that the drain filter must be
cleaned.
13 Programme selector dial
The selector is divided into 5 sections:
• Cotton, linen
• Synthetics
• Delicates
• Woollens
(hand washing)
• Special programmes
• Reset programme O
The selector dial can be turned either clockwise or
anticlockwise.
Position E corresponds to the ENERGY SAVING
programme and position
At the end of the programme the selector dial
must be turned to position O (reset).
14 Display
The display shows the following information:
Duration of the programme - Delayed start -
Incorrect option selection - Alarm code - End of
programme.
Duration of the selected
programme
After selecting a programme, the duration is
displayed in hours and minutes ( for example 2.05).
The duration is calculated automatically on the basis of
the maximum recommended load for each type of fabric.
After the programme has started, the time remaining
is updated every minute
Delayed start
The selected delay (23 hours max) set by means of
the relevant button appears on the display for 3
seconds, then the duration of the previously selected
programme is displayed.
The countdown is updated every hour and when
remain the last 2 hours each 30 min.
41
to "cold wash".