Bosch HBG5785 0B Series Buku Petunjuk - Halaman 17

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Oven Bosch HBG5785 0B Series. Bosch HBG5785 0B Series 44 halaman.

Halaman Cetak

Setting the timer

The timer runs alongside other settings. You can set it

at any time, even if the appliance has been switched off.

It has its own audible signal so that you can tell whether

it is the timer or a cooking time that has elapsed.

The maximum time that can be set is 23 hours and 59

minutes. Up to 10 minutes, the timer duration can be

set in 30-second increments.Above 10 minutes, the

time increments become longer the higher the value.

The timer duration will start at a different default value,

depending on which button you touch first:

5 minutes if you touch the A button and 10 minutes if

you touch the @ button.

Touch the v button until the timer symbol t is

underlined.

Use the A or @ button to set the timer duration.

After a few seconds, the timer duration will start to

count down.

If the set timer duration is the duration for which

Tip:

you wish to cook your food, use the cooking time. The

appliance will then switch off automatically when it has

finished cooking.

The timer duration has elapsed

An audible signal will sound. The timer duration will be

zero on the display.

Touch any button to switch off the timer.

Changing and cancelling

You can use the A or @ button to change the timer

duration at any time. After a few seconds, the change

will be applied.

To cancel, use the A button to reset the timer duration

all the way to zero. The timer is now switched off.

Checking time-setting options

If time-setting options have been set, the corresponding

symbols are lit up on the display. The symbol for which

the time is currently being displayed will be indicated.

To check the values for the different time-setting

options, touch the v button repeatedly until the

required symbol is indicated.

Setting the time

Once the appliance has been connected to the mains

or following a power failure, the clock will flash on the

display. Set the time.

The function selector must be set to the "Off" position.

Use the A or @ button to set the time.

The time will stop flashing.

Confirm by pressing the v button.

The appliance will apply the time you have set.

You can go to the basic settings to specify

Note:

whether or not the time should be shown on the display.

~ "Basic settings" on page 20

Changing the time

You can change the time again when you need to, e.g.

from summer to winter time.

To do this, when the appliance is switched off, touch the

v button until the symbol for the time is underlined, and

use the A or @ button to change the time.

Time-setting options