Electrolux EW6S427BI Panduan Pengguna - Halaman 31

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci Electrolux EW6S427BI. Electrolux EW6S427BI 36 halaman.

Halaman Cetak

Problem

The spin phase does

not operate or the

washing cycle lasts lon‐

ger than usual.

There is water on the

floor.

You cannot open the

appliance door.

The appliance makes

an unusual noise and

vibrates.

The programme dura‐

tion increases or de‐

creases during pro‐

gramme execution.

The washing results are

not satisfactory.

Too much foam in the

drum during the wash‐

ing cycle.

After the check, activate the appliance. The programme continues from the point of

interruption.

If the problem occurs again, contact the Authorised Service Centre.

If the display shows other alarm codes, deactivate and activate the appliance. If the problem

continues, contact the Authorised Service Centre.

Possible solution

• Set the spin programme.

• Make sure that the drain filter is not clogged. Clean the

filter, if necessary. Refer to "Care and cleaning".

• Adjust manually the items in the tub and start the spin

phase again. This problem may be caused by balance

problems.

• Make sure that the couplings of the water hoses are

tight and there is not water leakages.

• Make sure that the water inlet hose and the drain hose

have no damages.

• Make sure you use the correct detergent and the correct

quantity of it.

• Make sure that a washing programme that ends with

water in tub, has been selected.

• Make sure that the washing programme is finished.

• Set the drain or the spin programme if there is water in

the drum.

• Make sure that the appliance receives electrical power.

• This problem may be caused by a failure of the appli‐

ance. Contact the Authorised Service Centre.

• Make sure the levelling of the appliance is correct. Refer

to "Installation instruction".

• Make sure that the packaging and/or the transit bolts

are removed. Refer to "Installation instruction".

• Add more laundry in the drum. The load may be too

small.

• The SensiCare System is able to adjust the programme

duration according to the type and the laundry load size.

Refer to "The SensiCare System load detection" in "Dai‐

ly Use" chapter.

• Increase the detergent quantity or use a different deter‐

gent.

• Use special products to remove the stubborn stains be‐

fore you wash the laundry.

• Make sure that you set the correct temperature.

• Decrease the laundry load.

• Reduce the quantity of detergent.

ENGLISH