Draytek VigorAP 810 Panduan Memulai Cepat - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Titik Akses Nirkabel Draytek VigorAP 810. Draytek VigorAP 810 9 halaman. 802.11n
Juga untuk Draytek VigorAP 810: Panduan Memulai Cepat (10 halaman)
Halaman Cetak
Installing Your Router
This section will guide you to install the AP through hardware connection
and configure the settings through web browser.
Before starting to configure the router, you have to connect your devices
correctly.
1. Connect VigorAP 810 to ADSL modem, router, or switch/hub in your
network through the LAN A port of the access point by Ethernet cable.
Note: You can also connect VigorAP 810 to a Vigor router via wireless
connection. For detailed information, refer to VigorAP 810 User's
Guide.
2. Connect a computer to other available LAN A port. Make sure the
subnet IP address of the PC is the same as VigorAP 810
e.g., 192.168.1.X.
3. Connect the A/C power adapter to the wall socket, and then connect it to
the PWR connector of the access point.
4. Power on VigorAP 810.
Check all LEDs on the front panel. ACT LED should be steadily on,
5.
LAN LEDs should be on if the access point is correctly connected to the
ADSL modem, router or switch/hub.
,
management IP