Draytek VigorAP 903 Panduan Memulai Cepat - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Titik Akses Nirkabel Draytek VigorAP 903. Draytek VigorAP 903 16 halaman. 802.11ac access point
Juga untuk Draytek VigorAP 903: Panduan Memulai Cepat (13 halaman), Panduan Memulai Cepat (17 halaman), Panduan Memulai Cepat (16 halaman)
Halaman Cetak
3
.
I
n
s
t
a
l
l
a
3
.
I
n
s
t
a
l
l
a
This section will guide you to install the AP through hardware / wall-mounting
connection.
For hardware connection, refer to the following steps to connect your devices
correctly.
1.
Connect VigorAP 903 to xDSL modem, router, or switch/hub in your network
through the LAN A port of the access point by Ethernet cable.
You can also connect VigorAP 903 to a Vigor router via wireless connection.
For detailed information, refer to VigorAP 903 User's Guide.
2.
Connect a computer to other available LAN A port. Make sure the subnet IP
address of the PC is the same as VigorAP 903 management IP, e.g.,
192.168.1.X.
3.
Connect the A/C power adapter to the wall socket, and then connect it to
the PWR connector of the access point.
4.
Power on VigorAP 903.
5.
Check all LEDs on the front panel. ACT LED should blink, LAN LEDs should be
on if the access point is correctly connected to the xDSL modem, router or
switch/hub.
t
i
o
n
t
i
o
n
4