BDS EKF 450 Petunjuk Pengoperasian Asli - Halaman 7

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian Asli untuk Alat Listrik BDS EKF 450. BDS EKF 450 20 halaman. Ekf series 300; ekf series 500; ekf series 600

Halaman Cetak
GB
WARNING
Improper handling of the machine
increases the risk of injury!
Pay attention to the following safety
instructions in order not to injure others
or yourself:
►
Operate the machine only with the
protective equipment specified in
these instructions (see section "Per-
sonal protective equipment").
Do not wear protective gloves when
►
the machine is running. A glove can
be caught by the machine and torn off
the hand. Risk of losing one or more
fingers.
►
Remove loose jewellery before begin-
ning work.
►
Wear a hair net if you have long hair.
►
Always switch off the machine before
changing tools, performing main-
tenance or cleaning. Wait until the
machine has come to a complete
standstill.
►
Always remove the plug from the
mains socket before changing tools,
cleaning or performing maintenance
work in order to avoid unintentional
starting of the machine.
►
Do not put your hand into the ma-
chine while it is in operation. Remove
swarf only when the machine is at
a standstill. Wear protective gloves
when removing swarf.
►
Check that the tool is tightened
securely before using (see section
"Inserting the tool").
►
Do not allow the connecting cable to
hang over edges (trip effect).
EKF Series 300/500/600
Preventing damage
ATTENTION
Potential damage to property if the
machine is improperly used!
Observe the following instructions to
avoid damage to property:
►
Before connecting the machine,
compare the connection data (voltage
and frequency) on the type plate with
those of your mains power supply.
The data must correspond in order to
avoid damage to the machine.
►
Always use the handle to carry the
machine and not the connecting
cable.
►
Do not pull the mains cable to remove
the plug from the mains socket.
►
Do not crush the connecting cable.
►
Do not subject the connecting cable
to heat or chemical liquids.
►
Do not pull the connecting cable
across sharp edges or hot surfaces.
►
Lay the connecting cable in such
a way that it cannot be caught and
wound up in the rotating part of the
machine.
Safety
7