BDS EKF 545 Petunjuk Pengoperasian Asli - Halaman 13

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian Asli untuk Alat Listrik BDS EKF 545. BDS EKF 545 20 halaman. Ekf series 300; ekf series 500; ekf series 600

Halaman Cetak

NOTE

Observe the following instructions:

►

Never attach the reversing plates (20,

fig 6) to the material during standstill.

►

Maintain an even feed.

Push the machine slowly and evenly

in the opposite running direction of

the tool. (feed direction = from left to

right).

NOTE

Observe the following instructions:

►

Pay attention to the direction of rota-

tion marking on the supporting plate.

►

In the case of machines of the

EKF Series 500/600, the supporting

plate rotates to reduce friction during

processing.

►

Make sure that the machine and the

supporting plate rest on each other

evenly.

Before switching off, remove the ma-

chine from the tool.

Switch off the machine, see section

"Switching off the machine".

Pull the plug out of the mains socket.

EKF Series 300/500/600

Tool change

WARNING

Risk of injury!

►

Do not use damaged, soiled or worn

tools.

►

Change tools only when the machine

is switched off and at a standstill. Pull

the plug out of the mains socket.

►

After inserting, check that the tool is

engaged securely.

►

Only use tools, adapter and accesso-

ries that match the machine.

Replacing the milling cutter

To replace the milling cutter, proceed as

follows:

Loosen the side clamping screw (3,

fig. 4).

Unscrew the housing from the motor.

Loosen and remove the milling cutter

with the tool supplied.

Screw in the desired milling cutter.

Screw on the housing again.

Tight the clamping screw.

Tool change