AirStage UTY-VSGXZ1 Panduan Instalasi - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pemanjang AirStage UTY-VSGXZ1. AirStage UTY-VSGXZ1 6 halaman.
Halaman Cetak3.
Press SW4 (the set button) to
display the current address.
The address is set to A1 at
the factory.
4.
Press SW3 (the mode button) to select the address. The displayed
address changes as follows each SW3 button is pressed.
When the manual setting is selected, the indicators change as fol-
lows:
SIGNAL AMPLIFIER (Filter mode : OFF)
A1
A2
A8
SIGNAL AMPLIFIER (Filter mode : ON)
A1
A25
A56
Ex.) Address A5 is selected.
∙
Press the SW3 when
be displayed.
∙
If connecting multiple signal amplifiers, be sure to select a different
address for each amplifier.
If the same address is used for different signal
amplifiers, normal communication cannot be done.
5.
Press SW4 (the set button) to
set the selected address.
6.
Turn the power off and on or press SW7 (the reset button) to exit the
address setting mode and return to the normal mode.
If an address setting error occurs ("
cator), the address will not be set. Perform address setting again.
Normal mode
En-5
AMP Air Conditioning
Example 1) When A1 is set
Example 2) When A12 is set
A3
A4
A5
A7
A6
A26
A27
A28
A29
A30
A9-A16 or A57-A88 is displayed, then A1 will
Ex.) Address A5 is set.
" is displayed on the D19-indi-
Address setting error
91
ERROR CODE
Error code
Address setting error
Main PCB error
D9 LED lit or flashing
Communication error B
D9
D9
D14 LED lit or flashing
Communication error A
D14
D14
www.ampair.co.uk | [email protected]
Contents