Drazice OKC 200 NTRR / BP Panduan Pengoperasian dan Pemasangan - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemasangan untuk Ketel uap Drazice OKC 200 NTRR / BP. Drazice OKC 200 NTRR / BP 20 halaman. Stationary water heaters
Juga untuk Drazice OKC 200 NTRR / BP: Panduan Pengoperasian dan Pemasangan (17 halaman), Panduan Pengoperasian dan Pemasangan (12 halaman), Panduan Pengoperasian dan Pemasangan (19 halaman), Panduan Pengoperasian dan Pemasangan (20 halaman), Panduan Pengoperasian dan Pemasangan (18 halaman), Panduan Pengoperasian dan Instalasi (20 halaman), Panduan Pengoperasian dan Pemasangan (18 halaman), Panduan Pengoperasian dan Instalasi (13 halaman)

Halaman Cetak
Drazice OKC 200 NTRR / BP Panduan Pengoperasian dan Pemasangan

2.4 ELECTRIC WIRING

2.4.1 ELECTRIC INSTALLATION GENERAL INFORMATION

the electric wiring casing remove the partition corresponding with the input wire diameter of ∅8 or ∅10
Perform the connection according to the scheme. Factory connection must not be changed! (Figure 5) In
(Figure 4). The degree of protection of electric parts of the appliance is IP 45. Power input of electric
element is 4000 W.
Figure 4
It is necessary to observe the below requirements during the electric wiring:
•
The electric wiring scheme is attached to the appliance on the side of the electric
installation guard (Figure 5).
•
Connection, repairs, and wiring inspections may only be implemented by a company
(person) authorised to such activity.
•
Expert connection must be confirmed on the warranty certificate.
•
The appliance is connected to the 3/N/PE ~ 230V/50Hz electric network using a fixed
moving conductor with a switch that turns off all network poles and the circuit
breaker (protector).
•
Installations in bathrooms, lavatories and showers must comply with the standards.
•
The degree of protection of electric parts of the appliance is IP 45.
•
Respect the rules of protection against electrical injuries in accordance with
Standards.
Figure 5
- 12 -