Drazice OKC 200 NTRR / BP Panduan Pengoperasian dan Pemasangan - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemasangan untuk Ketel uap Drazice OKC 200 NTRR / BP. Drazice OKC 200 NTRR / BP 20 halaman. Stationary water heaters
Juga untuk Drazice OKC 200 NTRR / BP: Panduan Pengoperasian dan Pemasangan (17 halaman), Panduan Pengoperasian dan Pemasangan (12 halaman), Panduan Pengoperasian dan Pemasangan (19 halaman), Panduan Pengoperasian dan Pemasangan (20 halaman), Panduan Pengoperasian dan Pemasangan (18 halaman), Panduan Pengoperasian dan Instalasi (20 halaman), Panduan Pengoperasian dan Pemasangan (18 halaman), Panduan Pengoperasian dan Instalasi (13 halaman)

Halaman Cetak
Drazice OKC 200 NTRR / BP Panduan Pengoperasian dan Pemasangan

1.3 DESIGN AND GENERAL HEATER DIMENSIONS

The heater tank is made of a steel plate and tested by 0.9 MPa overpressure. The inside of the receptacle is
enamelled. A flange is welded onto the bottom of the tank with a flange lid screwed to it. A sealing ring is
inserted between the flange lid and the flange. Thermowells for placing a heating element and sensors of
regulation thermostat and safety fuse are located in the flange lid. Anode rod is mounted on M8 nut. The
water reservoir is insulated by means of polyurethane foam. Electric wiring is placed underneath the
plastic removable cover. The temperature of water can be set using the thermostat. In combined versions,
a heat exchanger is welded in the pressure tank. The heat exchanger is only intended for the heating
circuit.
- 6 -