Bosch HRS578B.6B Panduan Pengguna dan Petunjuk Instalasi - Halaman 20
Jelajahi secara online atau unduh pdf Panduan Pengguna dan Petunjuk Instalasi untuk Oven Bosch HRS578B.6B. Bosch HRS578B.6B 44 halaman.
Halaman Cetak
en Basic settings
Use the
or
button to set the time.
3.
a After a few seconds, the appliance starts heating
and the time counts down.
14 Basic settings
You can configure the appliance to meet your needs.
14.1 Overview of the basic settings
Here you can find an overview of the basic settings and factory settings. The basic settings depend on the features
of your appliance.
Display
Basic setting
Signal duration upon completion of a time or
timer period
Waiting time until a setting is applied
Button tone when pressing a button
Brightness of the display illumination
Time display
Childproof lock can be adjusted
Interior lighting during operation
Cooling fan run-on time
Telescopic shelves retrofitted
Sabbath mode available
Water hardness
→ "Setting the water hardness", Page 21
Reset all values to factory settings
..
Home Connect Settings
Factory setting (may vary according to model)
1
2
Depending on the appliance specifications
14.2 Changing basic settings
Requirement: The appliance is switched off.
Press and hold the
1.
four seconds.
a The first basic setting appears in the display,
e.g. .
Use the temperature selector to change the setting.
2.
20
2
button for approximately
a Once the time has elapsed, the display shows the
time as zero.
Switch off the appliance.
4.
Selection
= 10 seconds
1
= 30 seconds
= 2 minutes
1
= 3 seconds
= 6 seconds
= 10 seconds
= off
1
= on
= dark
1
= medium
= bright
= hide the time
1
= display the time
= no
1
= yes
= yes, with locked door
= no
1
= yes
= short
1
= medium
= long
= extra-long
1
= no
(for rails and 1-level pull-out)
= yes (for 2- and 3-level pull-out)
1
= no
= yes
= softened
= soft (up to 1.5 mmol/l)
= medium (1.5–2.5 mmol/l)
= hard (2.5–3.8 mmol/l)
= very hard (above 3.8 mmol/l)
1
= no
= yes
→ "Home Connect ", Page 21
Use the
or
button to switch to the next basic
3.
setting.
To save the changes, press and hold the
4.
for approx. four seconds.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
1
button