Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor Informasi Pengoperasian - Halaman 2

Jelajahi secara online atau unduh pdf Informasi Pengoperasian untuk Alat Listrik Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor. Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor 3 halaman. Bosch demolition hammer parts list
Juga untuk Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor: Panduan Referensi Cepat (25 halaman), Panduan Petunjuk Pengoperasian/Keselamatan (29 halaman), Daftar Bagian (2 halaman), Panduan Petunjuk Pengoperasian/Keselamatan (33 halaman), Panduan Petunjuk Pengoperasian/Keselamatan (33 halaman)

ELECTRONIC FEEDBACK CIRCUITRY (EFC)

The internal electronic feedback system provides a "soft start", which will reduce the stresses that occur from a high

torque start. The system also helps to keep the preselected impact rate and rotating speed virtually constant between no-

load and load conditions.

INSTALLING ACCESSORIES

Clean the insert shank end of the accessory to remove any debris, then lightly grease with a light oil or lubricant. Insert

accessory into the tool holder through the dust shield, while twisting and pushing inward until it locks automatically into

place. Pull outward on the accessory to be certain it is locked into the tool holder (fig. 2). NOTE: The high efficiency

available from the rotary hammers can only be obtained if sharp and undamaged accessories are used. The "cost" to

maintain sharp and undamaged accessories is more than offset by the "time saved" in operating the tool with sharp

accessories.

REMOVING ACCESSORIES

Warning:

Accessories may be hot after use. Avoid contact with skin and use proper protective gloves or cloth to

remove. To remove an accessory, pull and hold locking sleeve backward and pull bit forward. All accessories should

be wiped clean after removing.

"VARIO-LOCK"- SELECTOR RING

The vario-lock selector ring can be set in any one of twelve (30 degree increments) positions. Choose a position which is

best suited for your operation. To adjust, pull the selector ring forward and hold firmly, then turn both the accessory and

the selector ring to the desired position. Release the selector ring and turn the accessory slightly until it locks in place.