Electrolux 400 SERIES Panduan Penggunaan & Perawatan - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Penggunaan & Perawatan untuk Mesin pencuci piring Electrolux 400 SERIES. Electrolux 400 SERIES 16 halaman.

Halaman Cetak

Care and Cleaning

Burn

Hazard

Allow heating element to cool

before cleaning the interior.

Failure to do so can result in

burns.

Outside--Occasionally

wipe with a mild

nonabrasive

detergent

and water. Rinse and

dry.

Inside--The

inside of the dishwasher

is self-

cleaning with normal use. If needed, clean

around the tub gasket area with a damp cloth.

The filter is self-cleaning.

A glass trap located

in the center of the filter is designed

to collect

pieces of broken glass, straws, bones and pits.

To remove items in glass trap, grasp handle, lift

out, empty and replace.

Care of Drain Air Gap

If a drain air gap was installed for your built-in

dishwasher,

check to make sure it is clean so

the dishwasher

will drain properly. A drain air

gap is usually mounted

on countertop

and can

be inspected

by removing

the cover. This is not

part of your dishwasher

and is not covered by

warranty.

Property

Damage

Hazard

Freezing temperatures

may cause water

lines to rupture. Be sure all supply lines to

and circulating

lines within dishwasher

are

protected.

Failure to do so could result in property

damage.

Note: Hard water may cause lime deposit

buildup on the interior of the dishwasher.

For

cleaning

instructions

see "Removing

Spots

and Film" section.

Overfill

Protector--keeps

dishwasher

from overfilling

and is located in the left front

corner of the tub.

• Clean occasionally

with household

cleaner

containing

vinegar or

bleach to dissolve

any

buildup.

• Overfill Protector should

move up and down

freely about one inch. If

it does not move, lift

and clean underneath.

Winterizing

A dishwasher left in an unheated place should

be protected from freezing. Have a qualified

person do the following:

To Disconnect

Service:

Turn off electrical

power to the dishwasher

at the supply source by removing fuses or

tripping circuit breaker.

Shut off water supply.

Place a pan under the inlet valve.

Disconnect

water line from inlet valve and

drain into pan.

Disconnect

drain line from pump and drain

water into pan.

Restore Service:

1. Reconnect

the water, drain, and electrical

power supply.

2. Turn on water and electrical

power supply.

3. Fill both detergent

cups and run

dishwasher

through a NORMAL

cycle.

Check connections

to make sure they do

not leak.

Note: See Installation

Instructions

for more

details.