Care and Cleaning
Burn Hazard
Allow heating
element
to cool
before
cleaning
the interior.
Failure to do so can result in
burns.
Care of Drain Air Gap
If a drain air gap was installed
for your built-in
dishwasher,
check to make sure it is clean so the
dishwasher
will drain properly.
A drain air gap is
usually mounted
on countertop
and can be
inspected
by removing
the cover. This is not part
of your dishwasher
and is not covered
by
warranty.
Outside--Occasionally
wipe with a mild
nonabrasive
detergent
and water. Rinse and dry.
Inside--The
inside of the dishwasher,
including
the filter,
is self-cleaning
with normal
use. If needed,
clean around the tub gasket
area
with a damp cloth.
Property Damage Hazard
Freezing temperatures
may cause water lines to
rupture. Be sure all supply lines to and circulating
lines within dishwasher
are protected.
Failure to do so could result in property
damage.
Spray arm/tower
assembly
Note:
Hard water may cause lime deposit
buildup
on the interior
of the dishwasher.
For cleaning
instructions
see "Removing
Spots and Film"
section.
Overfill
Protector--keeps
dishwasher
from overfilling
and is located
in the left front
corner of the tub.
°
Clean occasionally
with household
cleaner
containing
vinegar
or
bleach to dissolve
any buildup.
°
Overfill
Protector
should
move up and
down freely about
one inch. If it does
not move,
lift and clean underneath.
Winterizing
A dishwasher
left in an unheated place should
be protected from freezing. Have a qualified
person do the following:
To
1.
Disconnect
Service"
Turn off electrical
power to the dishwasher
at
the supply source by removing
fuses or
tripping
circuit breaker.
2.
Shut off water supply.
3.
Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4.
Disconnect
drain line from pump and drain
water into pan.
Note:
See Installations
Instructions
for more
details.
To Restore Service:
1.
Reconnect the water,
drain, and electrical
power supply.
2.
Turn on water and electrical power supply.
3.
Fill detergent
cup(s) and run dishwasher
through a NORMAL
cycle.
4.
Check
connections to make sure they do not
leak.
Note: See Installations Instructions for more
details.
Halaman Cetak