Anchor AF-1502 Panduan Pengaturan Cepat - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Sistem Penyaringan Air Anchor AF-1502. Anchor AF-1502 11 halaman.

5. Remove the old filter and discard.

6. At this point, it is recommended to clean the

housing from inside.

7. Install the new filter in the housing. Make sure the

filter is correctly aligned.

8. Lubricate the o-ring and housing threads with food

grade silicone grease or petroleum jelly.

9. Support the base of the filter housing and insert it

back into filter cap by turning it clockwise until it is

hand tight.

NOTE: The housing should spin tight easily. If not, add more

lubrication to the housing threads. This will aid with removing

the housing when the filter needs to be replaced again.

10. Once the filter housing is hand tight, tighten it an

additional 1/4-1/2 turn with the supplied filter

wrench.

11. Repeat these steps for the other filter housings.

12. Turn the main water supply on and open a faucet

closest to the filtration system to release air.

13. Once the air has been released, push the red button on top of the

filter housing to release any additional air in the housing.

14. Check the housing for leaks and repairs, as necessary.