Anco BL9710A-SA Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Blender Anco BL9710A-SA. Anco BL9710A-SA 13 halaman.

Anco BL9710A-SA Panduan Pengguna
ICE CRUSH
1. Lay the appliance on a flat horizontal surface and make sure it is unplugged and the "Speed
knob" is turned to "OFF" position before operating.
2. Prepare some ice cubes with a size of 15mm*15mm*15mm, then remove the measuring cup
and jar lid. Put the ice cubes into the jar. Purified water has to be added to facilitate the smooth
running of appliance. The proportion of the ice and water is 2:3. The amount of mixture should
not exceed the maximum level as indicated on the jar.
3. Close the jar lid and measuring cup correctly in position. The jar lid must be closed properly,
or the appliance cannot be activated.
4. Install the jar onto the jar base. Make sure that the jar is installed correctly in position.
5. Connect the appliance into a mains power outlet socket.
6. Turn the "Speed knob" to "ON" position, and the indicator lights on the four buttons will
light up. Press the "Ice crush" button, and its corresponding indicator light will light up solidly
while the indicators of the other three buttons will be switched OFF and the blender will start to
work. Alternatively, you can turn the "Speed knob" to the speed settings ranged between
"Min" and "Max" at the "Speed knob" to crush ice at your desired speed.
NOTE: The speed cannot be adjusted by the "Speed knob" when the appliance is running in
the "Ice crush" mode.
NOTE: When crushing ice, if you want to stop the blender, press on the "Ice crush" button
again or turn the "Speed knob" to "OFF" position.
7. During operation, you can remove the measuring cup and then add ingredients into the jar
through the center opening of jar lid cover during operation, and then replace the measuring
cup.
NOTE: Do not remove the jar from the motor unit during working process. If it is necessary to
remove the jar, first turn OFF the appliance and then remove it.
CAUTION: Minimum 30minutes rest time must be maintained between two continuous
cycles.
8