Common Sense RC ACDC-6 Panduan Pengoperasian - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pengisi Daya Baterai Common Sense RC ACDC-6. Common Sense RC ACDC-6 8 halaman. 6s balancing charger
Halaman Cetak
2. Performance parameter：
2.1 Input voltage range
2.2 Charge current range
2.3 Discharge current range
2.4 Charge power limited
2.5 Discharge power limited
2.6 Balance current
2.7 Balance tolerance
2.8 NiCd/NiMH battery cell count
2.9 Lithium battery types
2.10 Lithium battery cell count
2.11 Pb battery voltage
2.12 Weight：
2.13 Dimensions：
3. Exterior and accessories
DC input port
button
Tem.
AC input
S ensor
Tem.sensor
4. Key features：
Mode
：mode selection/stop/back button.Press this key to
Esc
the mainmenu.and to stop during the process.
Dec. / Inc.
：reduce and increase button, you can browse other concerning informationsby this
button during the charge/discharge process.When you are setting parameters , press
Inc.
for reduce, and
key for increase.
Enter
：select/enter button,to start work by press it more than 2 seconds。
Start
2
DC11～18.0V
AC100～240V
0.1～5.0A
0.1～1.0A
max.50W
max.5W
max.300mA
+
0.01V
1～15cells
Li-po, Li-ion,Li-Fe
1-6series
2-20V
647g
134X 142 X 36 mm
L CD screen
output
balance p o r t
port
select in the main menu or back to
6. Warning and error messages
REVERS E POL ARI TY
CONNECTI ON BREAK
S HORT ERR
I NPUT VOL ERR
VOL S EL ECT ERR
BREAK DOW N
BATTERY
CHECK
L OW VOL TAGE
BATTERY
CHECK
HI GH VOL TAGE
BATTERY VOL TAGE
CEL L L OW VOL
BATTERY VOL TAGE
CEL L HI GH VOL
BATTERY VOL ERR
CEL L CONNECT
TEM P OVER ERR
Dec.
key
CONTROL
FAI LURE
The output is conne cted to a battery with incorrect
polarity
This will be displayed in case of detecting an interruption
of the connection between battery and output or voluntarily
disconnecting the charge lead during the operation of
charge or discharge on output
There was a short-circuit at output. please check the
charging leads.
The voltage of input power drops below the limit.
The voltage of Lithium battery pack was selected
incorrectly.Verify the voltage of battery pack carefully
There happens the malfunction at the charger circuit
by any reason.
The processor detects the voltage is lower t h a n you
set at Lithium program.please check the cell count
of the battery pack.
The processor detects the voltage is
set at Lithium program.please check the cell count
of the battery pack.
The voltage of one of the cell in the Lithium battery pack
is too low.please check the voltage of the cell
one by one.
The voltage of one of the cell in the Lithium battery pack
is too high.p l e a s e check the voltage of the cell
one by one.
There are bad connection at the individual connector.
please check the connector and cables carefully
The internal temperature of the unit goes too high. cool
down the unit.
The processor can not continue to control the feeding
current by any reason.The unit needs to be repaired.
higher
than you
11