Atherton ATT043 Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Monitor Atherton ATT043. Atherton ATT043 11 halaman. 4.3" tvi/ahd test monitor

Turn ON & OFF the monitor

 ON - Press the power button can turns monitor ON, the Power LED will indicates

green light. If there is no available signal input, the screen will shows "No Signal" &

blue background for 6 seconds then vanish and at the meantime Power LED

indicates flashing light. Monitor will auto-power-off if signal doesn't available for 10

minutes for save battery power. Repeat the procedure to turns monitor ON if the

monitor auto-power-off.

 OFF - Press and hold the power button for approximate 3 seconds to turns monitor

OFF.

Feeding the signal

 Use BNC connector to feeding composite video signal onto "CVBS IN" terminal.

 Use BNC connector to feeding TVI or AHD signal onto "AHD/ TVI" terminal.

Looping the signal

 Connect the BNC terminal "CVBS OUT" for output purpose.

 Connect the BNC terminal "AHD/TVI OUT" for output purpose.

Battery bar indicator

 The battery life will shows on top right corner of the screen to indicate the rest of

battery life. During the battery indicator down to last bar, both battery and Charge

LED indicator start to flashing when input signal available.

 The battery life indicator defined as follows:

Battery Charging.

Battery level OK.

Battery level is slightly down, but adequate power remains.

Battery remains around 30 minutes running time.

Battery remains around 10 minutes running time. Battery indicator will

become flashing RED if continue to use. The monitor will shut down in about

1 minute.

[NOTE]: The battery life will vary correspondence with CONTRAST/ BRIGHTNESS/ VOLUME/ DC OUT

setting, the higher setting value the less battery life sustained.

Display on the screen

Battery life indicator

Information setting & display