formlabs Form Wash Panduan Memulai Cepat - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pembersih Perhiasan Ultrasonik formlabs Form Wash. formlabs Form Wash 13 halaman.

Set Wash Time

Wash parts for 10 minutes in fresh IPA.

Turn the knob to navigate the display menu and adjust the wash time.

Push the knob to select or confirm. Wash parts for 10 minutes. Wash for

additional time when using partially resin-concentrated IPA.

Check for recommended wash times at formlabs.com/wash-support.

The wash cycle begins when the platform and basket lower. Ensure the

outer lid closes. To adjust the wash cycle time, push the knob to access

the display menu. The pause option will raise the platform and basket.

The platform mount and basket raise automatically at the end

of the wash cycle. Any IPA that drips onto the inner lid as parts dry

will drain into the wash bucket. Thoroughly drain IPA from printed

parts; carefully check and drain concave or hollow geometries that

may hold IPA. Allow parts to dry for at least 30 minutes after washing

and draining.

Remove the build platform or parts from the basket, depending on

the wash method used in step 1.

After washing parts on the build platform, use the removal tool,

scraper, or flush cutters to remove parts. Learn more about part

removal and preparing prints for use in Form Cure at:

formlabs.com/cure-support