ATI Audio MX101 Panduan Pengoperasian dan Pemeliharaan - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemeliharaan untuk Mixer Musik ATI Audio MX101. ATI Audio MX101 17 halaman. Mono output mixers and input expander
Halaman Cetakload will be driven with equal and anti-phase levels on the HI and LO output
lines. An unbalanced (one side grounded) load will cause the driver IC to shut off
the signal output to the grounded side of the load and double the output level ap-
plied to the other side, thus maintaining equal output to either type of load. The
output stage will drive loads of 600 ohms and higher. Nominal output is +4dBm
with clipping at +22dBm into balanced loads. Maximum output at clipping is re-
duced by 6dB when driving an unbalanced load, since the full output swing of on-
ly one driver is available. A jumper plug, P1, located just behind the output XLR
connector selects either +4dBm line level or -50dBm microphone level output.
HEADPHONES
A front panel 1/4" TRS (stereo) jack and thumbnail-adjust gain control provides a
monaural, in-phase signal to both sides of a set of stereo headphones. Only ste-
reo headphones should normally be used with the MX100; however, mono
phones can be used in a pinch at reduced levels. The headphone output pro-
vides 100mW to phones of up to 600 ohm impedance and reduced levels into
higher impedance phones. On the MX101, a panel switch can select a split lis-
tening mode which allows a pre-fade listen feed to one ear either from Mixer In-
put 1 or from an external director's cue fed thru a rear 2.5mm Tip-Sleeve jack.
Inserting a plug into the rear cue jack interrupts the feed from Mixer Input 1. The
cue headphone level is adjusted with an internal trimpot, R84, and is not affected
by the front panel headphone level adjustment.
LED METERING
A ten segment, three color LED bargraph display meters the output with a VU
average response characteristic. Internal meter calibration pot R70 sets the 0VU
meter reference to +4dBm output level and is adjustable to read 0VU for outputs
from -10 to +8dBm.
COMPRESSOR/ LIMITER
The MX101 and the MX100C incorporate a low distortion optical compressor with
a front panel switch and peak indicating LED. The compressor threshold adjust-
ment, R76, is factory set for a sine wave threshold at +3VU meter indication. The
threshold setting is independent of the actual mixer output level.
SLATE MICROPHONE AND TEST TONE OSCILLATOR
The MX101 includes a sensitive slate microphone built into the front panel with a
momentary switch to activate it. The compact nature of the MX101 precluded a
ATI Audio Inc.
■ Tel: 856-626-3480
Fax: 856-504-0220
www.
audio.com
■
■