CommScope AEKT Lembar Instruksi - Halaman 3
Jelajahi secara online atau unduh pdf Lembar Instruksi untuk Kandang CommScope AEKT. CommScope AEKT 4 halaman. For commscope s4-90m-r1-v2 antennas
Halaman Cetak
MAXIMUM TORQUE
M5
4.6N.m (3ft.lbs)
M6
8.0N.m (6ft.lbs)
M10
37N.m (27ft.lbs)
M12
58N.m (43ft.lbs)
13
16
14
7
Passive antenna
Step1 Remove the EMPTY BOX assembly from the pole
14
15
16
M12 bolt
Step 3 Assemble the antenna and bracket
Step 4 Assemble the antenna and radome
www.commscope.com
© 2019 CommScope, Inc. All rights reserved.
Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.
All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639853 B (09/19)
These four screws
and plastic spacers
are always kept
installed on wind
shield.
M10 bolt
18
19
20
1
Instruction of replacing wind shield with S4-90M-R1-V2
Step 2 Disassemble the EMPTY BOX
13
16
14
17
Fix the wind shield
after jump cables
are installed
Maintenance
wire is to prevent
the wind shield
from falling while
maintaining the
antenna.
Step 5 Mount the antenna assembly on the pole
GAP
Do not hit the endcap of the passive antenna
during installation. Leave 5 mm gap between
two endcaps.
639853
Pre-bend cable
per cable installation
instruction. Tie the
cable here
Page 3 of 4