Advanced Keys AK-104 Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Starter Jarak Jauh Advanced Keys AK-104. Advanced Keys AK-104 11 halaman. Smart keyless entry system

Halaman Cetak
ACCESSORY HARNESS WIRING DESCRIPTIONS
Wiring Description:
White
OUTPUT
(Starter Kill Relay is not required if installed with AK-PSB05)
Depending on jumper
(JP2)
Starter Kill Relay Control (Default)
When-Armed. While armed (Smart Key not detected or LOCK
button pressed) this output provides a constant GND to disable the
starter circuit when an unauthorized ignition is commenced. Connect
the Starter Kill Relay according to the wiring diagram on the right.
Ground-When-Disarmed
(Smart Key is detected or UNLOCK button pressed) This output can
be used as an enable signal to an immobilizer bypass or known as
Ground-When-Running. Alternatively this output can connect to any
system that requires an input signal when a Smart Key is sensed.
Purple
OUTPUT
This output provides an encrypted signal to the Engine Push-Start Ignition controller only when system
sense a valid Smart Key or disarmed via the UNLOCK button or from the Bypass Transponder Card.
Brown
INPUT
Connect to the brake pedal switch that output +12v when brake is applied, GND or float when released.
Note: This input is required for Smart Key programming and Ignition-Controlled Lock function.
Blue
OUTPUT
Connect to the optional Auto Window Closer Module trigger input.
Green
INPUT
directly. Change jumper (JP1) to
Positive Door Trigger if door
switch is a positive-triggered type.
Red
INPUT
**Required for Remote Start option**
connected to a +12v source when ignition key is i n the ACC
position. Note: With this input active, controller will stop search
for the Smart Keys to conserve
unintended lock actuation while the vehicle is running.
White
Purple
Brown
Blue
Green
Red
Ensure all connections are completed and properly secured
prior to connecting the wire harnesses to the module.
NOTE
̶
500mA Starter Kill Relay Control
selection this output can be used for:
Also known as Ground-
Provides a GND signal while disarmed.
~
100mA Push-Start Module Control
+
Brake
̶
100mA Window Closer Module Control
̶
Door Switch
Door
-
Switch
Dome
Input
Light
+12v
(Default) Negative Door Trigger (-)
+
ACC
REQUIRED
This input must be
battery and avoid
Starter Kill Relay Control
JP2
Push-Start Module Control
OPTIONAL
Window Closer Module Control
OPTIONAL
JP1
JP2
Starter Kill Relay (Included)
Starter
85
Kill Relay
COM
Control
86
START (+)
ON
ACC
OFF
Engine Push-Start Ignition Controller.
JP1
Door
Dome
Switch
Light
Positive Door Trigger (+)
VEHICLE
CIRCUIT
© Copyright Advanced Keys Inc. 2011. All Rights Reserved.
-
~
Brake
+
-
Door Switch
-
+
ACC
+
87
NO
30
NC
87A
ENGINE
START
Door
Switch
Door
Input
Switch
+12v
START
ACC
Input
ON
ACC
OFF
5