CommScope FACT Panduan Petunjuk Instalasi - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Peralatan Industri CommScope FACT. CommScope FACT 9 halaman. Fanout fixation kit
Juga untuk CommScope FACT: Instruksi Instalasi (8 halaman), Instruksi Instalasi (12 halaman), Instruksi Instalasi (8 halaman)
Halaman Cetak
5.3.2.
Feed the strength member to the backside.
Fix the calbe with 2 tie wraps and cut them.
Fix the strength member by using the allen key.
5.4.
Loose tube Ø < 2,5 mm handling
5.4.1.
If loose tubes are Ø 2-2,5 mm, guide the tubes
one by one into the tube holder of the cable termination
unit.
5.4.2.
If loose tube are < Ø 2 mm, guide them via the side
slit into the tube holder of the cable termination unit.
Page 4 of 9
© 2018 CommScope, Inc. All Rights Reserved
5.5.
1x flex tube Ø 12 mm
5.5.1.
Install the Ø 12 mm flex tube with special flex cover
as shown in the picture.
5.5.2.
Feed all loose tubes through, as shown.
5.6.
Loose tube Ø > 2,5 mm and
possibility to divide bare fibers
5.6.1.
For loose tubes Ø > 2,5 mm and dividing bare
fibers, secure the cable and flex tube in the rack where the
FACT is mounted. Feed the loose tubes into the flex. Mark
the loose tubes at 2 cm. Strip the loose tube and clean the
fibers.
5.6.2.
Example of dividing bare fibers to different trans-
portation tubes.
2 cm