Dreaming Robots Electric Eel Wheel Nano 2 Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Robotika Dreaming Robots Electric Eel Wheel Nano 2. Dreaming Robots Electric Eel Wheel Nano 2 12 halaman.

Halaman Cetak

Initial Setup

When you receive the EEW, you need to spend a few minutes

putting together some parts. No tools are required for this

assembly.

First, assemble the bobbins. Screw the bobbin disks onto a bobbin

tube.

Next, slide a bobbin onto the flyer. Put a metal bearing onto the

back of the flyer and slot the whole flyer assembly into the base.

Finally, put the black drive belt on the motor pulley, and then wrap

it around the flyer in the drive belt groove. Slide the tension string

into the bobbin pulley. When you start spinning, you can adjust the

tension dial; see the "Adjusting Uptake" section below.

Starting Procedure

1) Turn the speed dial on the side all the way counterclockwise to

make sure the speed starts at zero.

2) Plug the USB extension cord into the wall plug or into any 2A

USB port and the other end of the USB extension cord gets

plugged into the USB switch.