Formula Sound NN106 Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengaduk Formula Sound NN106. Formula Sound NN106 18 halaman. Multi input mixer

The features and layout of the NN106 are intended to provide the user with a creative tool

suitable for DJ mixing, live mixing and home studio mixing.

The NN106 has 6 channels, each channel has four inputs selectable by a rotary switch, the

fourth input is fed from a single dual stereo USB input. There is also a seventh input

which is the console microphone input.

Channel 1 and 2 each have a low impedance microphone input on XLR sockets, stereo

line input on RCA phono sockets, balanced line input on ¼" jacks and one of the two

stereo USB inputs. A recessed switch selects USB stereo channel 1 or USB stereo

channel 2. Phantom power (17V) is available for the microphones (recessed switch)

and gain adjustment (recessed).

Channels 3 to 6 each have a low impedance microphone input on XLR sockets, stereo

line input on RCA phono sockets, phono input on RCA phono sockets and one of the

two stereo USB inputs. A recessed switch selects USB stereo channel 1 or USB stereo

channel 2. Phantom power is available for the microphones (recessed switch) and gain

adjustment (recessed).

Each channel has a 4 position input select switch, clip indicator LED, gain control, 3 band

"full kill" EQ, FX loop select switch, AUX switch, XFA switch, XFB switch, cue switch

and channel fader.

The FX loop switch sends the signal to the FX LOOP stage in the output section, and then

onto the FX loop jack sockets, if nothing is connected to the jack sockets the signal is

automatically returned to the channel via the FX LOOP stage wet/dry control. If more than

one channel has the FX loop selected then the facility is disabled, this is because if multiple

FX switches are enabled there would be multiple sends and multiple returns without a

disable mechanism so we have included circuitry to sense when more than one FX switch

is selected.

The FX LOOP stage includes selectable variable frequency high and low pass filters and a

selectable compressor. The variable frequency high pass filter is adjustable from 20Hz to

2Khz; the variable frequency low pass filter is adjustable from 20Khz to 2Khz.

The compressor threshold is indicated by an LED and the threshold and ratio may be

adjusted by recessed pots in the base of the unit.

The MIC in each channel has selectable phantom power, gain control and a recessed

switch that allows the MIC to be put on a separate MIC bus or following the normal

routing. There is a recessed switch in the base of the unit that allows the MIC buss to be

included in the booth or to be fed post booth (as the console MIC), if the MIC buss is fed

post booth then it will also operate the voiceover circuit along with the console MIC.

Channels 1 – 6 are assignable to cross fader, however if MIC is selected and the MIC is

selected to the MIC buss then the MIC signal will not be assigned to the cross fader. The

cross fader has a fader curve control located just above the cross fader.

The console MIC is upper right on the NN106 and includes recessed

phantom power switch and recessed gain trim. There is volume control, 3

band EQ (+5dB to -26dB); MIC ON/OFF switch and cue switch on the

front panel.

The master output is balanced stereo on XLR's which may be strapped for

NN106 INTRODUCTION