Anden A130F Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Dehumidifier Anden A130F. Anden A130F 12 halaman.

DRAIN INSTALLATION

The drain outlet on the dehumidifier can be hard piped using a 3/4" PVC Slip x 3/4" MNPT fitting and 3/4" nominal drain tubing or the provided 3/4"

MNPT x 3/4" hose barb fitting and 3/4" clear PVC tubing can be used to drain the dehumidifier� Always maintain a constant downward slope from the

dehumidifier to the drain and do not allow soft tubing to curl up which may result in air lock� NOTE: PTFE thread seal tape is recommended for the

threaded connection and hand tighten only� If hard pipe is used, PVC primer and cement is recommended for the slip fit connection�

A level surface is required to ensure proper drainage from the dehumidifier�

A condensate pan is recommended when locating in or above a finished

space or suspending over the canopy� Adhere to local codes regarding

draining of the condensate pan� If a condensate pump is needed, install

it in the condensate pan as well�

Install a condensate overflow safety switch (i�e� float switch) in the

condensate pan, remove the factory installed jumper wire between

the Float Switch terminals on the control and wire the float switch to

the dehumidifier as shown in FIGURE 3� Overflow safety switches on

condensate pumps can be wired to the Float Switch terminals in a

similar fashion�

FIGURE 3 – FLOAT SWITCH WIRING

90-1857

NORMALLY CLOSED

FLOAT SWITCH