Electrolux ZHTAROW60 Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin pencuci piring Electrolux ZHTAROW60. Electrolux ZHTAROW60 16 halaman.

Halaman Cetak

STARTING

•

Open the water supply cock.

•

Switch on at the mains.

•

Leave the hood and check that all the components

are in their correct position.

•

Close the hood and press button "A".

The indicator light of button "A" (Figure 17) comes on,

indicating that the dishwasher is powered and that

water is being introduced and heated. The word "FILL"

is shown on the display during the entire filling and

heating stage:

If the hood is opened during this stage the message

"CLOSE" will appear on the display:

The filling and heating stage has finished when the dis-

play shows the tank temperature:

To display the boiler temperature during heating of the

tank, leave the hood and press the button "J"

(Figure 17).

WASH CYCLES

The wash cycle includes one wash with hot water and

detergent (min 55 °C) and one rinse with hot water and

rinse-aid (min 82 °C).

This machine can operate in 2 modes, "high productivity"

and "thermal label" (factory default). When the machine

is configured in "high productivity" mode, the

parameters which define the cycle times and

temperature set points are the standard parameters

(see table of times), whereas when the machine is

configured in "thermal label" mode, the parameters are

specific for this mode and such as to guarantee wash

cycles according to the "thermal label" standards (see

table of times).

Table of times

Standard cycle time with supply water at 10 °C.

ZHTAROW / EHTAROW /

OHTAROW

Thermal label mode

High productivity

Led "G"

)

(Figure 17

OFF

77"

90"

54"

90"

A device lengthens the cycle time if the water in the

boiler has not reached the minimum temperature for

correct rinsing.

The cycle times and the temperature may be personal-

ised (e.g. increase of the rinse time and temperature).

The cycle times should only be set by a specialised

technician.

OPERATION

The filling and heating stage has finished when the dis-

play shows the tank temperature:

The appliance is then ready for use:

•

Leave the hood.

•

Pour the required amount of detergent into the tank

(in models without automatic dispenser).

•

Insert the rack containing the dirty dishes.

•

Close the hood and select the suitable wash cycle;

the corresponding indicator light comes on and the

wash cycle starts:

- Cycle I

For lightly soiled dishes: press button "J" (Figure 17)

(see table of times).

- Cycle II (recommended)

For normally dirty dishes: press button "H" (Figure 17)

(see table of times).

- Cycle III

For very dirty dishes: press button "F" (Figure 17) (see

table of times).

- High productivity / Thermal label cycle

Press and hold button "G" (Figure 17) (see table of

times) to switch from "high productivity" to "thermal

label" mode and vice versa.

The LED corresponding to button "G" is OFF when the

machine is configured in "thermal label" mode (factory

default). The LED switches ON when the button is

III

pressed and the machine is configured in "high

productivity" mode.

150"