Electrolux C335FF Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembeku Electrolux C335FF. Electrolux C335FF 20 halaman. No frost chest freezer
Halaman Cetak
10 electrolux cold
The manufacturer declines any liabili-
ty should these safety measures not
be observed.
Electrical Requirements
Before switching on, make sure the elec-
tricity supply voltage is the same as that
indicated on the appliance rating plate.
The appliance is supplied with a 13amp
plug fitted.
In the event of having to
change the fuse in the plug supplied, a
13amp ASTA approved (BS1362) fuse
must be used.Should the plug need to
be replaced for any reason. The wires in
the mains lead are coloured in accor-
dance with the following code:
Green and Yellow:
Blue:
Brown:
The wire coloured green and yellow must
be connected to the terminal marked
with the letter "E" or by the earth symbol
or coloured green and yellow.
The wire coloured blue must be connect-
ed to the terminal "N" or coloured black.
The wire coloured brown must be con-
nected to the terminal marked "L" or
coloured red.
Upon completion there must be no cut,
or stray strands of wire present and the
cord clamp must be secure over the
outer sheath.
How to use
Temperature alarm
If the temperature in the freezer
becomes too high, the acoustic alarm
sounds and the alarm signal lamp
flashes.
The acoustic alarm signal sound and the
red alarm signal lights up:
Press the button to stop the acoustic
alarm signal. The red alarm lamp
continues to flash until the freezer
reaches the proper temperature.
on putting the equipment into service
until the temperature necessary for
safe food storage is maintained.
after loading fresh food in a quantity
exceeding the freezing capacity
"Freezing")
if the lid remains open for long time.
If there is a malfunction and the internol
Earth
temperature cannot be maintained.
The acoustic alarm signal fails to sound
Neutral
and the red alarm indicator fails to light
Live
up:
if the power supply to the equipment
fails
in the case that the electronic temper-
ature controller has failed.
Prior to putting into service
Clean the inside of equipment and all the appli-
ances prior to putting into service the first time
(see chapter: "Maintenance")
Adjusting the temperature
setting
Use a coin to turn the temperature control
knob. This is to render it more difficult to
change the setting inadvertently (protection
against children`being able to tamper with
the equipment).
Position "Off" means that the equip-
ment is switched off.
(see